User manual STANTON RM.402

[. . . ] Repeated compression of the cord may lead to electrical shorting. · To avoid damage due to AC voltage peaks, always disconnect your mixer from the power source during electrical storms. · Your mixer contains no user-serviceable parts. The manufacturer is not responsible for any damage or personal injury resulting from unauthorized user-servicing or modifications. [. . . ] Cue Level knob: Adjusts the cue level being sent to the Headphone outputs. Keep this at a reasonable level to avoid hearing loss. Cue Stereo/ Split toggle switch: Select whether you prefer to hear the Cue mix and Master output in stereo, or split with the Cue mix on one side and the Master on the other. Description of Functions 6. Headphone outputs: Connect up to two pairs of stereo headphones using 1/4-inch and 1/8-inch jacks. Cue Pan slider: This adjusts the relative headphone balance between the Cue mix (PFL) and Master output (PGM). Fader Start switch: Lets you automatically start a CD player from the cue point by moving the crossfader (requires a compatible CD player like the Stanton S-Series). Crossfader: Creates a gradual fade between two channels, as determined by the Crossfader Source selectors (14). Essential for scratching and smooth house mixing. Master fader: Adjusts the overall level of the Master output signal. Master Stereo/Mono toggle switch: Selects whether the Master output will be stereo or summed to mono. PFL switch: Push this to assign the channel to the Cue mix in headphones. (Pop quiz: Do you know what "PFL" stands for?Answer: "Pre-Fader Level. " In other words, the Channel fader does not affect the level you hear in the headphone cue mix. ) 13. Channel fader: Controls the input channel level. Crossfader Source selectors: These select whether the input channel is assigned to the left side (A) or right side (B) of the crossfader. Select "BYPASS" if you don't want the channel assigned to the crossfader at all. Input Gain knobs: Use these to adjust the level of inputs. For optimum signal-to-noise, raise the knob until the "max" LED lights occasionally (usually around the 2 o'clock position). Description of Functions 16. Input Selector switches: Use these to choose between the Phono, Line and Mic inputs. Talkover switch: Switch this to the "ON" position to enable Microphones 1 and 2. When moved to the "Talkover" position, the music is lowered by a preset amount when the mic is in use. Mic Level knobs: Use these to adjust the levels for Microphones 1 and 2. [. . . ] Depending on the input, check the rear panel selector switches. Check the top panel channel selector switches. No Sound No Sound- Master Output (Booth and Zone are OK) Make sure that MASTER TRIM on the rear panel is turned up. No Sound Headphones Do the headphones work with the CUE pan in the PROGRAM position but not PFL?If so, make sure that the channel PFL switches are engaged. Check the CUE LEVEL control. Signal level is low even with the faders and input level controls turned up. Check to make sure the talkback switch is NOT engaged on the microphone input. [. . . ]