User manual STANTON S-650 MK II

[. . . ] S-650 MK II TRACK M S F TRACK M S F S-650 MK II S-650 MK II IMPORTANT TO SAFETY WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. Handle the power supply cord carefully Do not damage or deform the power supply cord. If it is damaged or deformed, it may cause electric shock or malfunction when used. When removing from wall outlet, be sure to remove by holding the plug attachment and not by pulling the cord. [. . . ] Frame search is mostly used to set an accurate cue point. SKIP Use these buttons to go back to the beginning of the current track or select a previous track for playing. (13)CUE Indicator When in CUE mode, the CUE indicator lights. (14)CUE (Cue Button) Pressing the CUE button during play provides a return to the position at which play was started. (30) CONTINU Indicator When the indicator lights, the function will cause the unit to play continuously. (31) SINGLE Indicator When the indicator lights, playback will stop at the beginning of the next track. (32) REMAIN Indicator It indicates that the time shown on the display is the remaining time of playing track. (33) PITCH DISPLAY Shows the current percentage of pitch change, pitch range is selectable from +/-8%, 12%, or 16%. 24 25 26 27 28 29 30 31 32 33 (24) ~(27)TRACK, MINUTE, SECOND and FRAME Display These displays indicate information for the CD's current position and time. (28) BAR Indicator These ten indicators provide a visual display of the approximate position of the pickup within the current track. PREPARATIONS 1. Checking the Contents Check that the carton contains the following items: 1) Main unit 2) Control unit 3) Operating instruction 4) Pair of RCA pin cord. Installing the Unit Mount the unit into your console or rack with 19" EIA rack rails. CAUTION: The player will work normally when the main unit is mounted with the front panel at within 15 degrees of the vertical plane. If the unit is tilted excessively, discs may not be loaded or unloaded properly. 15 The control panel's LCD's are designed to be clearly visible within the angles shown in Figure 2. Mount the control unit so that the visual angle is within this range. 45 5 Main unit Control panel Button . Figure 1 Figure 2 Connections 1) Turn off the POWER switch. 2) Connect the RCA pin cord to the input on your mixer. 3) Connect the control cords to the REMOTE connector on the main unit. CAUTION: Be sure to use the supplied control cords. Using another type of cable may result in damage. Be sure the power is off when connecting the control cords. Otherwise the units may not work properly. 6 OPERATIONS 1. Opening and Closing the Disc Holder Turn the unit power on. [. . . ] NOTE: Relay play may not work properly if the audio out jacks on the two players are not connected to the same audio amplifier. Press PROG and SGL button to switch relay function; the indicator on the LCD track display when flash when relay is on. 15. Key This button activates the KEY Correction function. This function will allow you to make adjustment to a track speed using the pitch control without altering a track perceived tonal pitch. When KEY is on, Pitch LED is flashing; and LED is off when KEY is off. 16. Fader Start Playback When the player's CONTROL jack is connected to a mixer with fader start connection, raising the DJ Mixer's channel fader causes the player's standby mode to be released, starting playback instantly. [. . . ]