User manual STANTON SA5

[. . . ] 33312 PL E A S E RE A D C A R E F UL LY B E F O R E U SE FAI LU R E TO F O LLO W TH E I N S TR U C TI O N S PR I N TE D B E LO W M AY V O I D WAR R AN TY · Follow all security advice printed on your mixer. · When removing the unit's AC plug from the power source, grasp and pull the plug, NEVER the cord itself!· Avoid placing your mixer near heat sources, such as power amplifiers. · When in use, place your mixer on a stable surface, away from vibration. [. . . ] Follow the steps below to rotate the OS2 to the position you like: 1. Remove the two outer screws from the OS2 as indicated in diagram. Removing the two inner screws will detach the OS2 from its plate. Rotate the OS2 to the position you like. Replace the two outer screws to secure the OS2 in place. Remove switch from mixer and detach the connector from switch. Attach the connector for OS2 to the replacement switch and replace two outer screws to secure the OS2 in place. 1. 4. Session Level control: Controls the input level of the session or mic input, depending on setting of session/ Mic switch (27). Gain: Controls the gain of each input channel. The sensitivity of the gain faders is adjusted by the phono trim (25) knob on the back of the mixer. Program Reverse: Reverses the signal of input channels 1 and 2. When switched down, channel 1 will control channel 2's inputs. Master Volume control: Controls the overall signal output level of the mixer. The sensitivity of this fader is controlled by the master trim knob (21). Line Fader Reverse: Reverses the direction of each respective line fader. When switched down, the channel will be at full volume when the fader is down. The volume will decrease as the fader is moved upward. 3. REPLACING THE OS2: 1. 2. 5. FADER CLEANING AND REPLACEMENT After constant scratching, the SA-5 faders may need to be cleaned and lubricated from time to time. This will ensure long life and keep a smooth feeling throughout the fader's lifetime. Follow the instructions below to lubricate and clean your faders: REMOVING A FADER: 1. Make sure mixer is powered off and power supply is disconnected from the back of the mixer. To remove the lower faceplate, take off all the fader knobs and then remove the 4 screws located on the sides of the mixer (2 on each side). [. . . ] Some newer turntables such as the Stanton STR8-150 do not require a ground cable because they are grounded internally. Session Input: This extra line level input is controlled by the session level fader (1) when the Session/Mic switch (27) is switched to session (the up position). It can be used as an extra line input or as a session input for team routines. 33 35 36 35 37 33. Headphone output: Standard 1/8" (mini jack) headphone output connector. [. . . ]