User manual STRONG SRT 200 USB BROCHURE

[. . . ] · Do not touch a power cord with wet hand. · Place the receiver in well ventilated and no-heat environment. · When connecting cables, the receiver must have been powered off. · Do not plug in/out CI module, when the receiver is powered on. [. . . ] Have your Dealer aim the dishes at the requested satellites and connect the LNB's with coax cables to the IN connectors of the DiSEqC 1. 0 switch. Connect the OUT connector of the DiSEqC 1. 0 switch to the LNB IN connector at the back of your receiver. Figure 7. Connecting a fixed satellite dish to your receiver Figure 8. Connecting multiple fixed dishes to your receiver using a DiSEqC 1. 0 switch 13 14 Connecting to Dish Connecting to CI Module <Connecting a dish on a motorized positioner to your receiver> 3. 3 Connecting to CI Module(CI Model Only) Another possibility to watch program from multiple satellites is by mounting a dish to a motorized DiSEqC 1. 2 positioner. Have your t dealer mount the dish to the positioner, set the or react azimuth(angle of elevation) and let him set the center point for your positioner. Connect the LNB with a coax cable to the LNB IN connector of the positioner, and connect the OUT connector of the positioner to the LNB IN connector at the back of your receiver. Insert CI module into CI slot for watching TV program from Service Provider. Do no plug in/out CI module when the receiver is powered on. But you can insert smart card to CI module with power on. Figure 9. Connecting a dish on a motorized positioner to your receiver Figure 10. Connecting to CI Module 15 16 Connecting to CI Module 3. 4 Connecting to SMART CARD Insert Smart Card into Smart Card slot for watching TV program from Service Provider. Setting and Operations 4. 1 Before Settings <Starting up for the First Time> 1. If it is first time using a receiver, you should set parameters for system configuration. For the following setup you have to know the right frequency for your LNB(s). Press the OK button in the Antenna Setup menu of Installation <Screen 6> The Antenna Setup window will be displayed as below <Screen 7>. Setting and Operations 3. If you want to scan with a fixed antenna, set the LNB and various switch values in <Screen 7> following to your physical antenna setting. <screen 8> If your antenna is installed well and the signal strength of the program is good, the strength bar will be shown as green. If you want scan selected Satellite, Press RED button in RCU. If you want scan all Satellite, Press BLUE button in RCU. <screen 6> 2. In this Scan Antenna window, you can manipulate the current antenna lists or see the values of antenna configurations. For editing antenna name, Press GREEN button in RCU. <Screen 7> In the edit window, you can see one edit field and a keypad box, and you can move between edit field and keypad box easily with cursor key. If you change channel, the banner bar will be displayed for few seconds as<Screen 15>. The function of remote control buttons in Normal viewing mode state is as follows. - MUTE : Audio mute(displayed on left-upper) - PAUSE : Video Freeze - Digital TV/RADIO : Shows you the list of stored TV/RADIO channels. - SAT : You can select all satellites or a satellite to view. - FUNC : If you press the FUNC button once, a banner is displayed on the upper part of the screen. [. . . ] Check the receiver according to the procedures shown below. If the receiver does not work properly after checking it, please contact the dealer. It may cause a dangerous situation. Symptom The display on front panel does not light up No picture or sound Cause The power cord is not Plugged in. Remedy Check that the power cord is plugged in to the wall outlet. <screen 29> Wrong connection of the Audio/Video output of the receiver to TV. [. . . ]