User manual STRONG SRT 4121

[. . . ] English CONTENTS CONTENTS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . GENERAL PROPERTIES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . SAFETY PRECAUTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . POWER SOURCE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] and 5 user defined satellites as User1User5 append to them. The satellites can be renamed by remote control. Low Frequency: You should set this value according to low oscillator frequency of your LNB device (by default 9750 for Universal LNB). High Frequency: You should set this value according to high oscillator frequency of your LNB device (by default 10600 for Universal LNB). Polarisation: You can select antenna polarisation as Horizontal, Vertical or both (H/V). 22 kHz: You can select frequency band as low or high by choosing Off or On respectively. If you select Auto, receiver decides 22KHz On or Off depending on frequency. DiSEqC (Off / Tone A / Tone B / DiSEqC 1 / DiSEqC 2 / DiSEqC 3 / DiSEqC 4): You should set this according to switch position of the desired satellite; if your LNB device is connecting directly to your receiver we advise you to select Off mode. LNB Power: You can enable/disable LNB supply, this must be set to On if the receiver is not connected to other box via loop- through. 14 English 6. 4. 3. ADD NEW CHANNELS After highlight the Add New Channels by pressing up/down keys, press OK button or right key. This menu includes: 1. Manual Search Except satellite name, all parameter values are dependent to satellite name so when you toggle this button, the whole parameters are updated automatically. To give an idea about the signal level, or you can say power level, there is a Signal Level indicator in this menu. It updates after you change any parameter. For all items operation is the same, after highlight the item and change value by toggling (by pressing ö / ö keys). After pressing Start Scan the user will be asked whether he would like to start scan or not?By pressing OK, all channels and channels (predetermined in database) of that satellite will be searched and stored into receiver, this operation is called as Preset Search. 6. 4. 3. 1. AUTOMATIC SEARCH The user can scan some or all satellites for only free to air or all channels by this menu. Menu items: Satellite Name: The satellite selection is made by toggling. Symbol rate1/2/3: Additional symbol rates for newly added transponders are entered directly by 0, 1, 2, 9 keys. For every well-known satellite like ASTRA, HOTBIRD there is a symbol rate table, which is formerly stored into receiver. So the scan function is performed according to this table or additional symbol rates if there exist. 6. 4. 2. FIRST TIME INSTALLATION It is an advanced type menu. [. . . ] Battery exhausted. Press the standby key check if nothing blocks the front panel. Change the batteries. You see the on-screen error message The dish installation is not correct related with LNB short-circuit protection mode. or cable connections have been made incorrect. Check the connections. If the problem persists, contact with the closest service for help. 30 English 8. [. . . ]