User manual STRONG SRT V50

[. . . ] Controlled by receiver or optional remote control. Just like stand-alone positioner 2 PART 1 · English Power On/Off RESET English Lock/unlock the positioner Sat. keys (0-9) Enter Key Cancel the previous command Browse stored Satellite positions Store a Satellite position Set software east / west limits Manually adjust direction to East / West Shift: Adjust all the stored satellite positions 3 PART 1 · English 3. 0 BASIC OPERATION Front View Manual Buttons 3 Digit LED Display 1K Indicator 5 V DC (Optional for Optical Sensor Connect to Receiver and LNB (Via Coaxial Cable) Pulse Ground (Connect to Reed Switch Sensor) Connect to Motor (36 V DC Output) Manual Buttons For South Hemisphere: The East / West buttons should be exchanged. East ( West West East) Power / Store 4. 0 DIGITS LED DISPLAY 1. The total antenna position Index (pulse counts) is 2, 000 (0 ~ 1, 999). [. . . ] To enter LOCK MODE, press Lock key on remote control and then press Enter button in 2~3 seconds to lock the positioner. The display will show "Loc" after blinking, and all the other functions cannot be triggered except power on/off, and DiSEqC commands from receiver. To unlock, press Lock key with following Enter button again to unlock the positioner. 7 English PART 1 · English Lock Enter Restore Factory Default (Reset): This function will clear all data in the Positioner, includes High/Low Limits, Satellite Positions, . . . , etc. Press the Power button on the top of the positioner and re-plug to the AC outlet. Keep pressing the Power button for 3 seconds. To stop the Reset process, unplug from the AC outlet before counting to 1. Keep pressing the "Reset" button on the remote control until the positioner finishes counting down from 10 to 1. To stop the Reset process, simply stop pressing the Reset button before the positioner counts down to 1. If reset has been successfully completed, it will show " æ æ æ " on the LED. (count number 1000). After 2 Seconds 7. 0 FOR DISEQC 1. 2 RECEIVER The denomination of some commands might be different, but similar. Please refer to the manual of the Receiver. Set the Software High / Low Limits: After sending the commands from the DiSEqC 1. 2 receiver, the Display of the positioner will show as below: Low Limit High Limit Low Limit North Hemisphere South Hemisphere East Limit West Limit East Limit High Limit West Limit Cancel the Software High / Low Limits: After sending the command from the DiSEqC 1. 2 receiver, the Display of the positioner will show "LoF". 8 PART 1 · English Store the Satellite Positions: 1. Drive the Actuator East / West until the picture on the TV screen is clear. 1 ~60 and then send Store command from the receiver. The Display will show "C01~C60" then show "P01~P60". Repeat Step 1 to 3 to set up all the satellites you prefer. Recall a Satellite Position: Change the satellite no. from the receiver, the positioner will drive the actuator to the intended position. However, if the position has not been stored yet, the positioner will ignore the command. Note: If the Channels and Satellites are well preset on the receiver, it will drive the actuator to the right position while user changes the Channels. After arriving the right position, the Display will show the Satellite no. [. . . ] Manual Buttons English East (West) / Down West (East) / UP Power / Store Recall a Satellite Position: Change the DiSEqC 1. 0 setting of the channels. (No response) Reset the positioner Unplug the AC Power Cord from the AC outlet. Wait for more than 10 seconds then re-plug. n This problem might be caused by the unstable AC power. [. . . ]