User manual STRONG SRT 6352 CI

[. . . ] Digital Satellite Receiver with Common Interface SRT 6352 CI User Manual Picture similar Safety Instructions SAFETY INSTRUCTIONS Grounding, Polarization -- If this product is used with a specified AC adapter, the adaptermay be equipped with a polarized alternating current line plug (a plug with one blade wider than the other). This safety feature allows the plug to fit into the power outlet only one way. If you cannot insert the plug into the wall outlet, pull it out, reverse it, and then reinsert it. If the plug still fails to fit, contact an electrician and have the receptacle replaced n Protecting the Power Cord -- The power supply cord should be placed so it will not bewalked on. [. . . ] "Parental lock" allow you to define system PIN code and lock access to the menu. 5. 2. 1 Channel set-up From this menu you can setup channels from satellite(s) in several modes, access to Dish setup menu, Positioner setup (if used). Satellite: move focus of the menu to this item. Press OK to display list of available satellites. Select satellite of your choice and press OK. If satellite doesn't exist in the list you should add it first using "Edit satellites" menu. Dish number: move focus of the menu to this item. Use tu buttons to select dish number to which above selected satellite belongs to. Press OK button to enter to Dish setup menu (see 5. 2. 2). Dish number "--" means that selected satellite do not belongs to any dish. Dish position: this item value depends from the mode of the Dish. if mode of selected dish is "Fixed" then this item is not selectable if mode of selected dish is "DiSEqC 1. 2" then value can be "Not stored" (in case dish position for selected satellite was not stored") or in range from 1 to 64 if position has been stored. Select item and press OK to setup positioner. More details about Positioner setup read in chapter 5. 2. 1. 1. if mode of selected dish is "GOTO X" then value is "GOTO X". Select item and press OK to setup GOTO X function. Transponder: move focus of the menu to this item and press OK. List of transponders of selected satellite will appear at right side of the screen. You can select transponder in order to check signal strength and quality of reception. Transponder list contains predefined transponders. If you need to modify transponder list please use menu "Edit satellites" as described in chapter 5. 2. 3. If you need to scan specific transponder then use Manual scan as described in this chapter below. [. . . ] Remedy Check that the power cord is plugged in to the wall outlet. Connect the Audio/ Video output of the receiver to TV correctly. Check the antenna cable, replace the cable, or connect the cable to the receiver tightly. Set the values of the tuner parameters correctly in the installation menu. [. . . ]