User manual STUV 16-CUBE

[. . . ] You have chosen to buy a Stûv fireplace ; Concept & Forme thank you for your choice. Your fireplace was designed to offer you the utmost pleasure, comfort and safety. It was built and assembled with the greatest care. If however you should find the slightest dissatisfaction with it, please contact your retailer. [. . . ] decorative elements can be added to personalize the stove. This solution includes an impeccable finish for the edges of the recess. The end of the frame [photo 3] must extend beyond the masonry (or the cladding) by at least 10 mm but by a maximum of 80 mm [diagram 4]. - Move register hood to the right to bring its notch level with the cursor [b] and then remove it [pic. - Fit the frame or cover in place from the front [pic. - Secure by starting with the 2 lower screws. With a frame with finish, adjust the depth so that it is fitted correctly [photo 1]. In the case of a thin frame, screw in the two M5 screws in the centre of top horizontal part [pic. 1] Refit register hood, first the right screw and then the left. Screw in the flap [b], photos 3 and 4 Check the screw on the right of the flap [photo 4] to ensure - that the magnet has sufficient force of attraction - and that the flap is vertical in a closed position. The magnet attracts the filings: keep the contact parts clean. Then : - Adjust legs at both ends ; the appropriate spanner is supplied with the cover. - The glass tablet will be held in place by suction pads. Position the glass and press to eliminate air from the pads - Refit the register hood ; first the right screw then the left. Contrary to other covers or frames, this one slides in from the top. - Remove galvanized steel cover It will serve no further purpose. - Take off the suspension ring [photo 3] by bending it several times. - Replace the 4 screws [photo 1] to avoid infiltration of air. - Remove the 4 screws with curved head [pic. - Slide in the cover from the top using special handles supplied [pic. The hanging wing slides between the stove and the hinges [pic. 6] - A claw inside the cover needs to catch in front of the smoke outlet ; pull forward as far as possible and press in the centre of the hood so that it catches [pic. [. . . ] repeat this along the length of the door. If the paper does not remain jammed, replace the seal. Glass door broken or cracked, seal worn-out, problems with the lining of the combustion chamber - contact your installation engineer. The guarantee is limited to the exchange of those parts that are recognised as defective, to the exclusion of any damages. [. . . ]