User manual SUB-ZERO 200 INSTALL GUIDE

[. . . ] MODELS 249R, 249R, 249FF AND 245 ROUGH-IN REQUIREMENTS IMPORTANT NOTE: To operate properly, the door must open a minimum of 90°. Use a minimum 2" (51 mm) filler in corner installations to assure a 90° door opening. Allow enough clearance in front of the unit for full door swing. IMPORTANT NOTE: Make sure the floor under the refrigerator is level with the surrounding finished floor. [. . . ] Remove the wood base by extracting all 4 levelers and then discard the wood base. Reinstall all 4 levelers back into the unit base assembly. Remove all packing materials and tape as well. Next, prelevel the unit by adjusting the leveler legs prior to pushing unit back into the installation. WARNING Keep door(s) and drawer(s) taped closed while moving unit. Illus. 1 7 200 SERIES C O M P L E T I N G T H E I N S TA L L AT I O N CAUTION Protect any finished flooring before moving the unit in place. If for any reason the unit has been laid on its back or side, for over a hour, you must allow the unit to stand upright for a minimum of 24 hours before connecting power. Adjust both the front and rear levelers by turning the levelers clockwise - to raise the unit, counterclockwise - to lower the unit. When the unit is leveled properly, or squared off, door adjustments are less likely to be necessary. (See Figure 3. ) IMPORTANT NOTE: Be sure to reference leveling of the unit to the floor and not to surrounding cabinetry. This could effect the operation of the unit, such as door(s) not closing properly. Step 10: After the unit has been leveled, install the kickplate as shown in illustration 2. Step 8: To complete the installation, first shut off power to the wall outlet. Plug into a 15 amp grounded outlet and roll the unit into position. Now you have to connect the ice maker water line (if applicable). Remove the 1/4" compression fitting from its plastic bag and join the water supply line to the solenoid valve. CAUTION IMPORTANT NOTE: Make sure to purge the water line prior to hooking up the water valve. Do not block the kickplate louvers with carpeting, baseboard or other materials. This will cause poor operation or product failure. IMPORTANT NOTE: Turn on the water supply and check all fittings for leaks. Make certain the electrical harness is attached to the solenoid. In areas with water of high mineral content, the use of an in-line water filter is recommended. Make sure the filter is positioned and accessible for replacement when necessary. IMPORTANT NOTE: Let your customer know that the ice maker will not fill with water immediately, and that the first three batches of ice produced should be discarded. Allow 24 hours to get proper ice production. Illus. 2 8 200 SERIES I N S TA L L I N G PA N E L S Before you begin installing panels, refer to the Panel Specifications Dimensions on page 5, and be sure you are working with the Sub-Zero panel design called for in your installation plans. [. . . ] · Is the water supply line (if applicable) connected to the compression fitting and not leaking?· Is the unit leveled properly on a solid floor?· Has the door panel been installed properly?· Are the kickplate screws back in position? [. . . ]