User manual SUB-ZERO 315W-PS

[. . . ] For corner installations, you need allow for a minimum 3" (76) filler so the door can open to 90°. If you are using some larger handle hardware, you will also need to take that into account. If you are installing a wine unit next to an existing Sub-Zero unit, you may have to allow for a filler strip. Also, if there is 2" (51) or less in between units, an optional heater kit will need to be installed to prevent moisture from forming in between units. [. . . ] A separate circuit servicing only this appliance is required. All Sub-Zero Wine Storage units are equipped with a power supply cord with a 3-prong grounding plug which must be plugged into a mating 3-prong grounding type wall receptacle. For Model 315W, locate electrical anywhere on the back wall. You must follow all National Electrical Code regulations. In addition, be aware of local codes and ordinances when installing your service. Refer to the Wine Storage Installation Instructions packed with the appliance, which provides step-by-step procedures for making sure the unit is installed properly. Dimensions in parentheses are in millimeters unless otherwise specified. 5 Planning Information Wine Storage Model 315W I N T E G R AT I N G C A B I N E T RY Unless you are installing a stainless steel unit, you will need to provide a door panel frame, where wine will be seen from the outside. If you order a stainless steel unit, the Model 315W will be shipped with the panel and hardware installed and you will merely install the Sub-Zero. The door frame of the unit has pre-drilled holes for our optional handle hardware. Refer to Hardware Considerations on page 8 for specifics about installing handle hardware on this overlay application. A solid panel must not be installed on a glass door unit, as this may cause moisture to form behind the panel. O V E R L AY PA N E L S The overlay panel applied to Model 315W should not be confused with the Built-In overlay panel application. The overlay panel will consist of only a frame and would be either the 5/8" (16) or 3/4" (19) panel you may be using. It is affixed directly to the door itself with screws through a series of pre-drilled holes in the perimeter of the door itself. You do not need any backer or spacer panel. The glass door opening of the Model 315W is designed to be exposed to room air circulation. Decorative overlays on the glass should be kept to a minimum. Also, rails and stiles can be increased in size but should not exceed cabinet manufacturers standard width. They cannot exceed overall door panel dimensions specified, as they would interfere with the operation of the door. The back sides of rails and stiles that will be visible through the glass door will need to be finished. Also, the inside edges of the frames must be finished to match the front surface. Dimensions in parentheses are in millimeters unless otherwise specified. 6 Planning Information Wine Storage Model 315W O V E R L AY PA N E L S The door frame of the unit has pre-drilled holes for our optional handle hardware. Refer to Hardware Considerations on page 8 for specifics about installing handle hardware on this overlay application. IMPORTANT NOTE: Model 315W is not available with a solid door. [. . . ] Contact your Sub-Zero dealer for specifics. To obtain local dealer information, visit the Locator section of our website, subzero. com. W O O D FA C I N G ­ W I N E S H E LV E S Sub-Zero has provided a natural cherry wood facing to each of its wine shelves in each model. If, however, you would like to replace these strips with wood more complementary to your design and surrounding cabinetry, you can. The Wine Shelf Wood Facing Dimensions illustration, on page 10, can be used as a full-scale template. [. . . ]