User manual SUB-ZERO 400

[. . . ] WINE STORAGE USE & CARE GUIDE Caring for your Sub-Zero and everything in it. CONTENTS Sub-Zero Wine Storage Sub-Zero Wine Storage Features Sub-Zero Wine Storage Models Sub-Zero Wine Storage Use & Care Keeping Wine at Its Best Troubleshooting Guide Service Information Sub-Zero Warranty 3 4 5 8 18 20 22 23 As you read this Use & Care Guide, take particular note of the CAUTION and WARNING symbols when they appear. This information is important for safe and efficient use of the Sub-Zero equipment. signals a situation where minor injury or product damage may occur if you do not follow instructions. states a hazard that may cause serious injury or death if precautions are not followed. In addition, this Use & Care Guide may contain an IMPORTANT NOTE which highlights information that is especially important. SUB-ZERO® is a registered trademark of Sub-Zero, Inc. SUB-ZERO WINE STORAGE THANK YOU Thank you for purchasing your new Sub-Zero wine storage unit. The ultimate in beauty, engineering, detailing and functionality, this wine storage equipment continues the Sub-Zero tradition of superior quality and reliability, giving you the peace of mind that your wine is stored properly, at the exact temperature you select. Your Sub-Zero wine storage model is protected by a warranty that is one of the finest in the industry. [. . . ] These variations are normal with the carbon finish and add to the unique character of colored stainless steel. To bring out the natural luster of all three finishes, lightly wipe the surface with a waterdampened microfiber cloth followed by a dry polishing chamois. All work should follow the grain direction of the finish. Better results are obtained by keeping the cloth in continuous contact with the stainless steel. GLASS DOOR CLEANING The glass door panel can be cleaned using any standard glass cleaner available on the market today. SIGNATURE POLISH INTERIOR CLEANING To clean interior surfaces and removable parts, wash with a mild solution of soap and lukewarm water with a little baking soda. Avoid getting water on lights, control panel and the solid cherry wood facing on the shelves. Do not use abrasive cleaners or cloths on any of the interior or exterior surfaces, including the glass door panel. Signature Polish is available from Signature Limited Laboratory, P. Box 13436, Dayton, Ohio 45413-0436, or 877-376-5474 (toll free). Before cleaning the unit, shut the electricity off at the control panel. Under no circumstances should you use a metallic or highly abrasive cleaner or cloth, as this will remove the carbon finish or scratch the classic or platinum finishes. 15 SUB-ZERO WINE STORAGE USE & CARE CLEANING CONDENSER CLEANING Clean the condenser area every three to six months. The cleaning schedule will depend on the amount of dust and lint that accumulates in this area. To access the condenser on your specific wine storage model, see Condenser Location. Use a soft bristle brush and vacuum hose to remove dust and lint from the condenser area. NOTE: To avoid bending the condenser fins, be sure to vacuum in the direction of the fins (up and down). CONDENSER LOCATION Models 424 and 424FS: On these models the condenser is located behind the kickplate. First, remove the kickplate to expose the condenser area. Models 427 and 427R: On these models the condenser is located behind the kickplate / grille. Remove the screws holding the kickplate / grille. This assembly will slide forward easily, giving you access to the condenser area. Model 430: The condenser is located behind the grille at the top of the unit. To remove the louvered grille, first open the door to access three Phillips head screws. Tilt the grille forward at the top and release the springs from behind the grille, and then lift off the grille. To remove a panel grille on Model 430, lift the grille up, then pull out at the bottom and down to release it from its mounting bracket. Before cleaning the condenser, shut the electricity off at the control panel. When you clean the condenser, wear gloves to avoid injury from the sharp condenser fins. Failure to clean the condenser could result in temperature loss or mechanical failure or damage. Grille Springs Kickplate Grille Screws (inside door) Condenser location ­ Models 424 and 424FS 16 Condenser location ­ Models 427 and 427R Condenser location ­ Model 430 SUB-ZERO WINE STORAGE USE & CARE L I G H T I N G I N F O R M AT I O N CABINET LIGHTING Models 424 and 424FS: In these models, rope-style lighting is mounted to the top of the cabinet and cascades down the entire front of the unit. Models 427, 427R and 430: These models have discreet lighting provided in two places. Rope-style lighting is mounted to the top of the cabinet and additional lighting is mounted in the control panel to illuminate the display shelf. [. . . ] For Models 427 and 427R, it is attached to the underside of the control panel. For Model 430, the plate is located inside the door near the top hinge on the main frame extrusion. Refer to pages 5­7 for location of the rating plate for your specific model. For warranty purposes, you will also need the date of installation and the name of your Sub-Zero dealer. [. . . ]