User manual SUB-ZERO CTWH36

[. . . ] Refer to Wolf Cooktop Ventilation Recommendations at the end of this section. Specifications are subject to change without notice. ACCESSORIES 36" (914) wall shield Flue extension to accommodate 10' (3 m) ceilings 8" (203) to 10" (254) round transition Accessories are available through your Wolf dealer. To obtain local dealer information, visit the Locator section of our website, wolfappliance. com. Dimensions in parentheses are in millimeters unless otherwise specified. 3 Planning Information Model CTWH36 Cooktop Wall Hood 507/8" (1292) MAXIMUM HEIGHT OF HOOD 3211/16" 6" (152) E (830) MINIMUM HEIGHT OF HOOD 4"(102) 21" (533) 357/16" (900) 8' TO 9' (2. 4 m ­ 2. 7 m) FLOOR TO CEILING HEIGHT 24" TO 30" (610 ­ 762) TO COUNTERTOP *8' (2. 4 m) ceilings will not allow for a 30" (762) maximum height above the countertop. Based on a 36" (914) high countertop, an 8' (2. 4 m) ceiling will allow for a maximum height above the countertop of 27 5/16" (694). DIMENSIONS Overall Width of Hood Floor to Ceiling Height Countertop to Bottom of Hood Minimum Height of Hood (fully collapsed) Maximum Height of Hood (full extension) Location of Electrical See Installation Instructions shipped with unit for detailed specifications. 35 7/16" (900) 8' (2. 4 m) to 9' (2. 7 m) 24" (610) to 30" (762) 32 11/16" (830) 50 7/8" (1292) Within shaded area Dimensions in parentheses are in millimeters unless otherwise specified. 4 Planning Information Model CTWH36 Cooktop Wall Hood I N S TA L L AT I O N N OT E S Refer to the illustrations and specifications for overall dimensions and installation specifics. Wolf cooktop wall hoods are recommended for use with Wolf electric and gas cooktops and integrated modules. [. . . ] The service should have its own 15 amp circuit breaker. Placement of the outlet is not critical, as long as you provide a minimum of 12" (305) of 120 V AC, 60 Hz power cable. Locate electrical within the shaded area shown in the Installation illustration. You must follow all National Electrical Code regulations. In addition, be aware of local codes and ordinances when installing your service. Wolf cooktop wall hoods have an 8" (203) round vertical discharge. Refer to the installation instructions shipped with each Wolf product for detailed specifications. This information can also be found on our website, wolfappliance. com. Dimensions in parentheses are in millimeters unless otherwise specified. 5 Planning Information Model CTWH36 Cooktop Wall Hood COOKTOP HOOD PLACEMENT (E) UPPER FLUE TOTAL HEIGHT TO CEILING (F) MAXIMUM HEIGHT OF (D) HOOD BOTTOM OF HOOD TO MINIMUM FLUE EXTENSION Wolf cooktop wall ventilation hoods come with a telescopic chimney flue that allows you to reach a ceiling height of 8' (2. 4 m) to 9' (2. 7 m) with a finished look. A flue extension to accommodate 10' (3 m) ceilings is available as a sales accessory. Installation of the wall hood should be 24" (610) to 30" (762) from the bottom of the hood to the countertop. IMPORTANT NOTE: 8' (2. 4 m) ceilings will not allow for a 30" (762) maximum height above the countertop. Based on a 36" (914) high countertop, an 8' (2. 4 m) ceiling will allow for a maximum height above the countertop of 275/16" (694). IMPORTANT NOTE: Both sections of the telescopic chimney flue must be installed in order for the chimney to be lifted for service. To determine placement of the cooktop wall hood, you must calculate the height of the telescopic chimney flue. Refer to the illustration and chart below. To calculate the height of the telescopic chimney flue: (A) TOTAL FLOOR TO CEILING HEIGHT (C) COUNTERTOP TO BOTTOM OF HOOD (B) FLOOR TO COUNTERTOP HEIGHT 1) First measure A (total kitchen height from finished floor to finished ceiling height). 2) Next measure B (height from finished floor to countertop). 3) Then determine the minimum C value (distance from countertop to bottom of hood). Refer to the chart for ceiling heights from 8' (2. 4 m) to 9' (2. 7 m). Dimension C must be greater than 24" (610) and less than 30" (762). [. . . ] Internal blowers are mounted inside the hood canopy or downdraft blower box. In-line blowers are mounted in between the hood and the exterior of the home. Remote blowers can be mounted on the roof or in some cases, on an exterior wall. Refer to the illustrations below for dimensions of Wolf in-line and remote blowers. [. . . ]