User manual SUB-ZERO GASRANGETOP INSTALL GUIDE

[. . . ] G AS R ANGETOPS INSTALLATION INSTRUCTIONS As you follow these instructions, you will notice WARNING and CAUTION symbols. This blocked information is important for the safe and efficient installation of Wolf equipment. There are two types of potential hazards that may occur during installation. signals a situation where minor injury or product damage may occur if you do not follow instructions. states a hazard that may cause serious injury or death if precautions are not followed. Another footnote we would like to identify is IMPORTANT NOTE: This highlights information that is especially relevant to a problemfree installation. WOLF ® is a registered trademark of Wolf Appliance Company, LLC W O L F G A S R A N G E TO P S I N S TA L L AT I O N R E Q U I R E M E N T S IMPORTANT NOTE: This installation must be completed by a qualified installer, service agency or gas supplier. IMPORTANT NOTE: Save these Installation Instructions for the local inspector's use. [. . . ] To obtain local dealer information, visit the Locator section of our website, wolfappliance. com. Keep combustibles such as solvents, cleaning fluids, mops and rags, away from the area surrounding all gas appliances. Fresh Air Intakes Location of fresh air intakes Dimensions in parentheses are in millimeters unless otherwise specified. 5 W O L F G A S R A N G E TO P S I N S TA L L AT I O N S P E C I F I C A T I O N S MINIMUM C L E A R A N C E S Wolf gas rangetops come in 36" (914) and 48" (1219) widths. Illustrations on pages 8­ 9 provide the overall dimensions and installation specifications for each width of gas rangetop. Refer to the Installation Specifications illustration for your model on pages 8­ 9 for the exact rough opening dimensions and location of the gas and electrical supply. IMPORTANT NOTE: Cabinet opening dimensions shown in the Installation Specifications illustrations must be used. These dimensions provide for required clearances. IMPORTANT NOTE: Caution must be used in planning the proper installation of the Wolf gas rangetop to avoid fires or damage to adjacent cabinetry or kitchen equipment. Be sure to follow the minimum clearances established in the finished rough opening dimensions. Refer to the Installation Specifications illustrations for your model on pages 8­ 9 for the exact rough opening dimensions. WA L L I N S TA L L AT I O N S Minimum clearances to combustible surfaces: Minimum 18" (457) clearance from bottom of upper cabinet to countertop, within 6" (152) minimum side clearance. Minimum spacing between overhead side cabinets must be greater than or equal to the nominal width of the rangetop. The maximum depth of overhead and side cabinets is 13" (330), within 6" (152) side clearance. 0" (0) clearance for adjacent combustible materials below the countertop, both sides and rear. Bottom of ventilation hood must be 30" (762) minimum to 36" (914) maximum from countertop. 6 I N S TA L L AT I O N I N S T R U C T I O N S MINIMUM C L E A R A N C E S W A L L I N S TA L L A T I O N S Minimum clearances for gas rangetops without a ventilation hood: Surface Burners or Griddle (G) Models: 30" (762) minimum vertical distance from countertop to combustible materials above the rangetop. Charbroiler (C) Models: 36" (914) minimum vertical distance from countertop to combustible materials above the rangetop. I S L A N D | P E N I N S U L A I N S TA L L A T I O N S Minimum clearances to combustible surfaces: Island Installations: Minimum 12" (305) clearance to rear wall that rises above the countertop. Peninsula Installations: Minimum 6" (152) clearance to side walls and minimum 12" (305) clearance to rear wall that rises above the countertop. Failure to do so can result in explosion, fire or death. IMPORTANT NOTE: The gas rangetop must be connected to a regulated gas supply. Connect the rangetop to the gas supply line. The gas supply line must be of adequate size to properly service all gas appliances. If local codes permit, a certified, 3' (. 9 m) long, 1/2" or 3/4" ID flexible metal appliance connector is recommended for connecting this rangetop to the gas supply line. The pipe coming off of the unit has 1/2" female threads. IMPORTANT NOTE: The supply line must be equipped with an approved external gas shut-off valve located near the rangetop in an accessible location. Do not block access to the shut-off valve. [. . . ] I M P O R TA N T N OT E You must follow all National Electrical Code regulations. In addition, be aware of local codes and ordinances when installing your service. The Wolf gas rangetop requires a 110/120 V AC electrical supply to operate the electronic ignition system. The 6' (1. 8 m) power supply cord provided with the rangetop is equipped with a 3-prong, grounded plug for protection against shock hazard. The service should have its own 15 amp circuit breaker. [. . . ]