User manual SUB-ZERO IM15

[. . . ] For true wok cooking, the burner sculpts the gas flame into a plume, focusing heat in the center of the wok, then dispersing it outward for precisely controlled cooking. The larger grate will handle your wok perfectly, but also accommodate even your largest stockpots, Dutch ovens and the like. The powerful burner exceeds 18, 000 Btu/hr (5. 3 kW). [. . . ] IMPORTANT NOTE: Review specific installation instructions for product to product capabilities When multiple cooktops or modules are installed side by side, refer to the countertop cut-out dimensions on page 6. A Wolf downdraft system, Cooktop or Pro ventilation hood is recommended. When installing a ventilation hood, refer to the specific requirements of the hood for the minimum dimension to countertop. Also refer to Ventilation Recommendations in the Cooktop Ventilation or Pro Ventilation sections of our website, wolfappliance. com. The Wolf gas multi-function cooktop requires a separate 120 V, 60 Hz power supply. The service should have its own 15 amp circuit breaker, and a grounded 3-prong receptacle should be located within the reach of the 6' (1. 8 m) power cord. Locate electrical within the shaded area shown in the Installation illustration on page 4. IMPORTANT NOTE: A ground fault circuit interrupter (GFCI) is not recommended and may cause interruption of operation. For the gas multi-function cooktop, the gas service may be supplied through the floor. Refer to the Installation illustration on page 4 for placement of electrical and gas supply. The Wolf gas multi-function cooktop is designed to operate on natural gas at 5" (12. 5 mb) WC (water column) pressure or LP (propane) gas at 10" (25 mb) WC pressure. The minimum line pressure for natural gas is 7" (17. 5 mb) WC and 11" (27. 4 mb) WC for LP gas. The maximum gas supply pressure to the regulator should never exceed 14" (34. 9 mb) WC; . 5 psi (3. 5 kPa). The cooktop is supplied with a 1/2" NPT male gas connection at the right rear bottom corner of the cooktop. The male connector exits the unit straight down and you are supplied with a regulator with two female connectors. Wolf gas cooktops using natural gas function up to an altitude of 8, 000' (2438 m) without any adjustment. Natural gas installations from 8, 000' (2438 m) to 10, 000' (3048 m) need the high altitude conversion kit. LP gas installations will operate up to 10, 000' (3048 m) without adjustment. You must follow all National Electrical Code and gas regulations. [. . . ] However, each unit must have its own regulator installed between the mainline and the cooktop or module. When two or more cooktops or modules are installed together, an integrated module filler strip is recommended. Contact your Wolf dealer for information on this accessory component. [. . . ]