User manual SUB-ZERO MICROWAVE

[. . . ] Planning Information Model MW24 Non-Convection Microwave Oven Door seals and sealing surfaces Model MW24 Free-Standing Ventilation openings (rear) Oven light Rating plate Interactive display Model MW24 with Optional Trim Safety door latches Control panel Oven door with window One-touch door open pad Door hinges Turntable Waveguide cover The Wolf Model MW24 24" (610) non-convection microwave oven can be used free-standing or with optional 30" (762) trim, it can be built in to fit above a Wolf 30" (762) built-in single oven. Optional trim is available in the classic stainless steel finish. What sort of microwave oven can you expect from a cooking company?This is the only non-convection microwave that deserves the Wolf name. [. . . ] The base platform must be able to support 125 lbs (57 kg). IMPORTANT NOTE: In all instances, where the microwave oven is built in, you must use the Wolf 30" (762) trim kit to ensure proper ventilation. The trim kit for the Wolf non-convection microwave oven will overlap cabinetry stiles and rails on all four sides. The trim overlaps 13/16" (21) on the bottom, 7/16" (11) on the top and 1 3/16" (30) on each side. Refer to the installation instructions provided with the trim kit for detailed specifications. These instructions can also be found on the Wolf website at wolfappliance. com. When using the Wolf microwave oven as a free-standing unit, allow 2" (51) of airflow space on top, rear and both sides. A minimum 20" (508) cabinet depth is required. The Wolf non-convection microwave oven requires a separate, grounded 120 V AC, 60 Hz power supply. The service should have its own 15 amp circuit breaker and a grounded 3-prong receptacle should be located within the reach of the 3' (. 9 m) power cord. Locate electrical within the shaded area shown in the Installation illustration. IMPORTANT NOTE: A ground fault circuit interrupter (GFCI) is not recommended and may cause interruption of operation. The Wolf non-convection microwave oven with trim may be installed in combination with a 30" (762) built-in single oven and/or warming drawer. Refer to page 6 for additional installation specifications. You must follow all National Electrical Code regulations. [. . . ] The warming drawer must be fully enclosed, top and bottom. For electrical requirements and additional specifications, refer to page 3, and to the Built-In Ovens and Warming Drawers section of the Wolf website at wolfappliance. com. Also refer to the installation instructions provided with each microwave trim kit and warming drawer front for detailed specifications. 30"min (762) CABINET 20"min (508) 17" (432) 20" min (508) 17" (432) 27 1/2" (699) NON-CONVECTION MICROWAVE OPENING WIDTH E 1"min (25) 1"min (25) 24"min (610) 27 3/16" (691) 24" min (610) 27 3/16" (691) 28 1/2" (724) 30-INCH OVEN OPENING WIDTH 7/8" (22) PLATFORM 2"(51) x 2"(51) ANTI-TIP BLOCK 5" 2 3/8" (60) (127) 9 1/8" (232) OPENING HEIGHT 7/8" (22) 9 1/8" (232) OPENING HEIGHT E 4" (102) 23 7/8"min (606) OPENING DEPTH 23 7/8" min (606) OPENING DEPTH 28 5/8" (727) WARMING DRAWER OPENING WIDTH PLATFORM APPLICATION ANTI-TIP BLOCK APPLICATION NOTE: Refer to the built-in 30" (762) single oven specifications for electrical location. Installation specifications for a non-convection microwave with 30" (762) trim installed above a 30" (762) built-in single oven and 30" (762) warming drawer with stainless steel drawer front. Dimensions in parentheses are in millimeters unless otherwise specified. 6 [. . . ]