User manual SUB-ZERO OUTDOOR GAS GRILLS

[. . . ] INSTALLATION GUIDE Outdoor Gas Grills Contents Wolf Outdoor Gas Grills . 15 Features and specifications in this guide and on the website are subject to change at any time without notice. Check our website, wolfappliance. com, for the most up-to-date specifications. Important Note To ensure the safe and efficient use of Wolf equipment, please take note of the following types of highlighted information throughout this guide: IMPORTANT NOTE highlights information that is especially important. CAUTION signals a situation where minor injury or product damage may occur if instructions are not followed. [. . . ] Wolf recommends the use of a minimum 1/2" (13) I. D. commercial type flex hose from the gas supply line to the grill connection. The units will operate on 1/2" (13) pipe to a maximum run of 30' (9 m). All plumbing to the flex hose must be 3/4" (19) minimum I. D. pipe. IMPORTANT NOTE: For complete gas shutdown, an external gas shut-off valve must be located near the appliance in an accessible location. Any LP gas cylinder used with this appliance must be constructed and marked in accordance with the specifications for LP gas cylinders of the U. S. Department of Transportation (D. O. T. ) or the National Standards of Canada CAN/CSA-B339, Cylinders, Spheres and Tubes for the Transportation of Dangerous Goods, and Commission, as applicable. Provided with a listed overfilling prevention device and a cylinder connection device compatible with the connection for outdoor cooking appliances. The LP gas cylinder must be provided with a shut-off valve terminating in the cylinder valve outlet. It must include a collar to protect the cylinder valve. The cylinder supply system must be arranged for vapor withdrawal. Do not use a cylinder that is dented, rusted or has a damaged valve. IMPORTANT NOTE: Do not operate the gas grill indoors or in any enclosed area. If the gas grill is not in use, the gas must be turned off at the LP gas cylinder. If the grill is to be stored indoors, disconnect the cylinder and leave it outdoors. Outdoor Grill Installation 13 wolfappliance. com LP Gas Installations PORTABLE LP CONNECTION LP GAS CONNECTION One of the many features of the Wolf grill cart is the pull-out shelf for easy access to the LP gas cylinder. It is designed to hold a 20-lb (5 gallon capacity) LP gas cylinder. 1) To install the LP gas cylinder, pull out the shelf and place the cylinder on it. 2) Check to ensure that the gas valve on top of the cylinder is closed. 3) Connect the LP gas regulator to the cylinder and hand-tighten only. Check for leaks according to the gas leak testing procedure on page 12. 4) Tighten the thumb screw to secure the cylinder to the shelf. Install the pressure regulator and hose assembly supplied with the grill as shown in the illustrations below. Connect the 3/8" flare end of the hose to the grill coupling using a 3/4" open wrench. Do not apply pipe sealant to the 3/8" flare connection. [. . . ] 2) Place the hex-grates directly above the briquette trays and make sure the square openings on the hex-grates are at the front. FLASH TUBE Flash tube position. Outdoor Grill Installation 16 Installation Checklist IMPORTANT NOTE: To ensure a safe and proper installation, the following checklist should be completed by the installer to ensure that no part of the installation has been overlooked. Troubleshooting IMPORTANT NOTE: If the outdoor gas grill does not operate properly, follow these troubleshooting steps: · Verify that gas is being supplied to the grill. · Check the gas supply and electrical connections to ensure that the installation has been completed correctly. · Check that control knobs are turned to the ON position and held in to active the igniters. · Follow troubleshooting procedures as described in the Wolf outdoor gas grills use & care guide. [. . . ]