User manual SUB-ZERO SRT INSTALL GUIDE

[. . . ] S EALED B URNER R ANGETOPS INSTALLATION INSTRUCTIONS As you follow these instructions, you will notice WARNING and CAUTION symbols. This blocked information is important for the safe and efficient installation of Wolf equipment. There are two types of potential hazards that may occur during installation. signals a situation where minor injury or product damage may occur if you do not follow instructions. states a hazard that may cause serious injury or death if precautions are not followed. Another footnote we would like to identify is IMPORTANT NOTE: This highlights information that is especially relevant to a problemfree installation. WOLF ® is a registered trademark of Wolf Appliance Company, LLC W O L F S E A L E D B U R N E R R A N G E TO P I N S TA L L AT I O N R E Q U I R E M E N T S IMPORTANT NOTE: This installation must be completed by a qualified installer, service agency or gas supplier. IMPORTANT NOTE: Save these Installation Instructions for the local inspector's use. [. . . ] If your installation requires a riser, it must be attached to the rangetop before installation. Refer to the installation instructions packaged with the riser. Gas supply and electrical connections should be made before the rangetop is placed in its final position. EXPLOSION HAZARD -- Use a certified gas supply line and install a gas shut-off valve. The maximum gas supply pressure to the regulator should never exceed 14" (34. 9 mb) WC (water column); . 5 psi (3. 5 kPa). Failure to do so can result in explosion, fire or death. TYPES OF GAS There are two types of gas, natural and liquid propane (LP). Conversions are required in order for appliances designed for one gas to be operated with the other gas. Such conversions must be performed by a Wolf authorized service center. Make sure your Wolf sealed burner rangetop is correctly adjusted for the type of gas being used. The product rating plate has information on the type of gas that should be used. The rating plate is located under the control panel on the far right. If this information does not agree with the type of gas available, contact your Wolf dealer. To obtain local dealer information, visit the Locator section of our website, wolfappliance. com. Wolf sealed burner rangetops using natural gas will operate up to an altitude of 8, 000' (2438 m) without any adjustment. Natural gas and LP gas installations from 8, 000' (2438 m) to 11, 000' (3353 m) need the high altitude conversion kit. Contact your Wolf dealer for details. 10 I N S TA L L AT I O N I N S T R U C T I O N S G A S S U P P LY R E Q U I R E M E N T S Before connecting the gas supply, make sure all valves are in a closed position. Do not connect the gas supply to an appliance that shows any sign of physical damage. If rigid pipe is used as a gas supply line, a combination of pipe fittings must be used to obtain an in-line connection to the rangetop. All strains must be removed from the supply and gas lines so the rangetop will be level and in line. IMPORTANT NOTE: The supply line must be equipped with an approved external gas shut-off valve located near the rangetop in an accessible location. Do not block access to the shut-off valve. IMPORTANT NOTE: All connections to the gas piping must be wrench-tightened. Do not make connections too tight, this may crack the gas pressure regulator and cause a gas leak. Do not allow the pipes to turn when tightening fittings as the tubing in the burner box may bend and begin to leak. [. . . ] If the burners do not light properly, turn control knob to the OFF position. Check that the burner caps are in the proper position. Check that the power supply cord is plugged in and that the circuit breaker or house fuse has not blown. Check that the shut-off valve is in the ON position. [. . . ]