User manual SUB-ZERO W302210I

[. . . ] This Wolf Pro low-profile wall hood has a 600 CFM internal blower. Wolf Pro wall hoods provide the ultimate in ventilation. With standard elements like heat sentry and dual setting halogen lighting, Wolf elevates the need for ventilation to an enjoyable perk. This 22" (559) deep model is the low-profile version, 30" (762) wide and available in the classic stainless steel finish. You also have the option of a decorative rail. [. . . ] Refer to the end of this section for Pro ventilation recommendations and blower options. IMPORTANT NOTE: Install this ventilation hood only with a Wolf blower. Pro wall hoods require a separate, grounded 110/120 V AC, 60 Hz power supply. The service should have its own 15 amp circuit breaker. Placement of the electrical supply is not critical, as long as you provide a minimum of 6" (152) of 120 V AC, 60 Hz power cable. Locate electrical within the shaded area shown in the Installation illustration. Note that the location of the electrical supply will differ between vertical and horizontal discharge blowers. You must follow all National Electrical Code regulations. In addition, be aware of local codes and ordinances when installing your service. Refer to the installation instructions shipped with each Wolf product for detailed specifications. This information can also be found on our website, wolfappliance. com. Dimensions in parentheses are in millimeters unless otherwise specified. 5 Planning Information Model W302210 I (R) Pro Wall Hood D U C T I N G C O N S I D E R AT I O N S Models W302210I and W362210I come with internal blowers, all other Wolf Pro low-profile wall hoods are shipped without the blower assembly. Internal, in-line or remote blower assemblies are available. The remote blower can be mounted on the roof or an exterior wall. Refer to the illustration below for ducting options. Pro low-profile wall hoods have an adjustable discharge location that can run vertically or horizontally. Horizontal discharge is applicable on low-profile wall hoods (excluding Models W302210I and W362210I) using a remote blower. Refer to the Pro ventilation charts at the end of this section for recommendations and blower options. DUCTWORK INSTALLATION THROUGH ROOF Ducting considerations for Pro low-profile wall hoods. ROOF CAP OR REMOTE BLOWER ­ TRANSITION FROM 8" (203) TO 10" (254) DUCT REQUIRED FOR REMOTE BLOWER 8" ROUND DUCT SOFIT OR CABINET OR DUCT COVER TRANSITION 17 3/4"W x 4 1/4"D TO 8" ROUND 3/8"H (INCLUDING FLANGES) 9 VERTICAL DISCHARGE 10" (254) HEIGHT OF HOOD WALL HOOD REMOTE BLOWER 22" (559) DEPTH OF HOOD DUCTWORK INSTALLATION THROUGH WALL DISCHARGE COLLAR HORIZONTAL DISCHARGE* 30" TO 36" (762­914) COUNTERTOP TO BOTTOM OF VENTILATION HOOD 36" (914) STANDARD FLOOR TO COUNTERTOP HEIGHT *HORIZONTAL DISCHARGE APPLICABLE ON LOW-PROFILE WALL HOODS (EXCLUDING W302210I AND W362210I) USING A REMOTE BLOWER. LOW-PROFILE WALL HOODS WITH AN INTERNAL BLOWER MUST USE VERTICAL DISCHARGE. Dimensions in parentheses are in millimeters unless otherwise specified. 6 Planning Information Wolf Ventilation Recommendations WOLF BLOWER ASSEMBLIES A ventilation system must include a blower assembly. With a few exceptions where internal blowers are included, Wolf ventilation hoods and downdrafts are shipped without the blower assembly. An internal, in-line or remote blower assembly must be selected to accommodate the cooking appliance, CFM requirements and homeowner preferences. Internal, in-line and remote blower assemblies are available as sales accessories through your Wolf dealer. Wolf internal, in-line and remote blowers are for use with Wolf cooktop hoods, downdraft systems and Pro ventilation hoods and hood liners. IMPORTANT NOTE: Use only a Wolf blower with all Wolf ventilation products. [. . . ] NOTE: For optimal performance, a Pro 27" (686) deep wall hood is recommended for use with ranges and rangetops that contain a charbroiler or griddle. Wall hood models without decorative rail listed; blower options are the same for (R) models. Transition with backdraft damper included with all wall hoods. Blower configurations are for reference only. [. . . ]