User manual SUB-ZERO WOLFDESIGN

[. . . ] DESIGN GUIDE OVENS | C OOKTOPS | RANGES | R ANGETOPS | BBQ GRILLS | V E N T I L AT I O N CONTENTS Wolf Built-In Ovens Wolf Electric Cooktops Wolf Gas Cooktops Wolf Integrated Modules Wolf Microwave Ovens Wolf Warming Drawers Wolf Dual Fuel Ranges 4 9 18 23 34 40 44 Wolf Sealed Burner Rangetops 51 Wolf Gas Ranges Wolf Gas Rangetops Wolf Gas BBQ Grills Wolf Cooktop Ventilation Wolf Pro Ventilation Wolf Ventilation Recommendations Wolf Warranty 57 64 68 72 82 92 99 Features and specifications indicated herein and on our website are subject to change at any time without notice. Check our website, wolfappliance. com for the most up-to-date specifications. IMPORTANT NOTE As you follow these instructions, you will notice warning and caution symbols. This blocked information is important for the safe and efficient installation of Wolf equipment. There are two types of potential hazards that may occur during installation. signals a situation where minor injury or product damage may occur if you do not follow instructions. states a hazard that may cause serious injury or death if precautions are not followed. WOLF ® is a registered trademark of Wolf Appliance Company, Inc. Another footnote we would like to identify is IMPORTANT NOTE: This highlights information that is especially relevant to a problem-free installation. WELCOME TO WOLF APPLIANCE In this Design Guide, you'll find all the necessary information for specifying a Wolf oven, cooktop, range, rangetop, BBQ grill or ventilation equipment into the next kitchen or home you design. [. . . ] Model WWD30 with integrated drawer front can accommodate installations with a 30" (762) or 36" (914) cooktop. It may also be installed in combination with a 30" (762) single or double oven or a 36" (914) single oven. Dimensions will vary according to the specific installation. Keep in mind that the width of the custom panel for the warming drawer with integrated drawer front will vary according to the specific installation. The opening width will remain 29 1/2" (749) whether installed in combination with a 30" (762) or 36" (914) cooktop or oven. The decorative wood drawer front panel must be a minimum of 5/8" (16) thick. ACCESSORIES Optional accessories are available through your Wolf dealer. To obtain local dealer information, visit the Locator section of our website, wolfappliance. com. ELECTRICAL REQUIREMENTS Model WWD30 requires a separate, grounded 120 V AC, 60 Hz power supply. The service should have its own 15 or 20 amp circuit breaker, and a grounded 3-prong receptacle should be located within reach of the power cord and flush with the back wall. Locate electrical within the shaded area shown in the installation illustrations on the following pages. IMPORTANT NOTE: When installed outdoors, a ground fault circuit interrupter (GFCI) is required to reduce the risk of electrical shock. STAINLESS STEEL DRAWER FRONT Wolf recommends using a 33" (838) wide cabinet for the warming drawer with stainless steel drawer front. A minimum 30" (762) wide by 24" (610) deep cabinet is required. OVERALL DIMENSIONS Model WWD30 with Stainless Steel Drawer Front 27 1/8" (689) OVERALL DEPTH 10 1/4" (260) 9" (229) 29 7/8" (759) OVERALL WIDTH 23 1/2" (597) BEHIND FRAME FRONT PANEL OPTIONS Model WWD30 Classic Stainless Model WWD30 with Integrated Drawer Front WWDFRONT/S WWDFRONT/B Platinum Stainless WWDFRONT/P Carbon Stainless Integrated WWDFRONT/I (accepts wood panel) Optional drawer front panels are ordered and shipped as sales accessories. Stainless steel drawer front panels include matching tubular handle. 10 1/8" (257) 9" (229) 29 3/8" (746) OVERALL WIDTH 23 1/2" (597) BEHIND FRAME Dimensions in parentheses are in millimeters unless otherwise specified. 41 WOLF WARMING DRAWERS I N S TA L L AT I O N S P E C I F I C AT I O N S Model WWD30 with Stainless Steel Drawer Front Undercounter Installation S P E C I F I C AT I O N S Model WWD30 with Stainless Steel Drawer Front 2" (51) x 2" (51) 33" (838) RECOMMENDED CABINET WIDTH 30" min (762) Overall Width Overall Height Overall Depth (behind frame) Rec Cabinet Width Min Cabinet Width Min Cabinet Depth Min Base Support Opening Width Opening Height Opening Depth Electrical Supply Heating Element Power Cord Shipping Weight 29 7/8" (759) 10 1/4" (260) 23 1/16" (586) 33" (838) 30" (762) 24" (610) 200 lbs (91 kg) 28 1/2" (724) 9 1/8" (232) 23 1/2" (597) 120 V AC, 60 Hz 15 or 20 amp circuit 850 W 3' (. 9 m) 3-prong 75 lbs (34 kg) ANTI-TIP BLOCK DIMENSION WILL VARY* 9 1/8" (232) OPENING HEIGHT 5" 4" 36" (914) STANDARD FLOOR TO COUNTER HEIGHT ALLOW FOR 5/8" (16) OVERLAP OF DRAWER FACE ON ALL SIDES (102) (127) E 23 7/8" min (606) OPENING DEPTH 24" min (610) CABINET DEPTH 28 5/8" (727) OPENING WIDTH 5" min (127) BOTTOM OF OPENING TO FLOOR *Allow enough room for placement of anti-tip block and drawer face overlap. Unit dimensions may vary to ± 1/8" (3). I N S TA L L AT I O N OPTIONS Model WWD30 with stainless steel drawer front may be installed above or below a Wolf 30" (762) single or double oven, or below an electric or gas cooktop, provided the warming drawer is fully enclosed, top and bottom, with a minimum base support of 200 lbs (91 kg). Refer to the built-in oven and cooktop sections for additional specifications. It may also be installed next to or above another Model WWD30. Model WWD30 with stainless steel drawer front may be installed in combination with a 30" (762) single oven and microwave oven with 30" (762) trim. Refer to the illustrations on pages 37 and 39. Refer to the installation instructions provided with the stainless steel drawer front for detailed specifications. These instructions can also be found on our website, wolfappliance. com. Dimensions will vary according to the specific installation. Installation below 30" Built-In Single Oven 24"min (610) CABINET DEPTH 24"min (610) CABINET DEPTH 33" (838) RECOMMENDED CABINET WIDTH 30" min (762) 28 1/2" (724) 24" min (610) 27 3/16" (691) 24" min (610) 27 3/16" (691) 30-INCH OVEN ROUGH OPENING 7/8" (22) PLATFORM 2" (51) x 2" (51) ANTI-TIP BLOCK 5" 2 3/8" (60) ALLOW FOR 5/8" (16) OVERLAP OF DRAWER FACE ON ALL SIDES 9 1/8" (232) OPENING HEIGHT 7/8" (22) 9 1/8" (232) OPENING HEIGHT 4" (102) (127) E 23 7/8"min (606) OPENING DEPTH 23 7/8" min (606) OPENING DEPTH 28 5/8" (727) WARMING DRAWER OPENING WIDTH PLATFORM APPLICATION ANTI-TIP BLOCK APPLICATION NOTE: Refer to the built-in 30" (762) single oven specifications for electrical location. 42 WOLF WARMING DRAWERS I N S TA L L AT I O N S P E C I F I C AT I O N S Model WWD30 with Integrated Drawer Front Undercounter Installation S P E C I F I C AT I O N S Overlay Application 2"(51) x 2"(51) ANTI-TIP BLOCK DIMENSION WILL VARY* Model WWD30 with Integrated Drawer Front 33" (838) RECOMMENDED CABINET WIDTH 30" min (762) Overall Width Overall Height Overall Depth (behind frame) Min Cabinet Width 5" min (127) BOTTOM OF OPENING TO FLOOR 29 3/8" (746) 10 1/8" (257) 23 1/2" (597) 33" (838) 24" (610) 25" (610) 200 lbs (91 kg) 29 1/2" (749) 10 1/4" (260) 24" (610) 10 1/4" 9 7/8"(251) (260) OPENING HEIGHT 5" 4" 36" (914) ALLOW FOR OVERLAP OF DECORATIVE DRAWER FACE ON ALL SIDES** (102) (127) E 24" min (610) OPENING DEPTH 24" min (610) CABINET DEPTH STANDARD FLOOR TO COUNTER HEIGHT 29 1/2" (749) OPENING WIDTH Min Cabinet Depth Overlay Inset Min Base Support Opening Width Opening Height *Allow enough room for placement of anti-tip block and drawer face overlap. **Overlap of decorative drawer face will vary depending on the size of the custom panel. Opening Depth* Inset Application 2" (51) x 2"(51) ANTI-TIP BLOCK DIMENSION WILL VARY* 33" (838) MINIMUM CABINET WIDTH Min Panel Size (W x H) Overlay 30" (762) x 10 3/8" (264) Inset 29 3/8" (746) x 101/8" (257) Min Panel Thickness Electrical Supply 5/8" (16) 120 V AC, 60 Hz 15 or 20 amp circuit 850 W 3' (. 9 m) 3-prong 75 lbs (34 kg) 10 1/4" 9 7/8" (251) (260) OPENING HEIGHT 5" 4" (102) (127) E Heating Element Power Cord Shipping Weight 36" (914) 24" (610) + THICKNESS OF DRAWER FACE FOR OPENING DEPTH STANDARD FLOOR TO COUNTER HEIGHT 29 1/2" (749) OPENING WIDTH 5" min (127) BOTTOM OF OPENING TO FLOOR 25" min (635) CABINET DEPTH *For inset application, add thickness of drawer face to opening depth. Unit dimensions may vary to ± 1/8" (3). *Allow enough room for placement of anti-tip block. Installation below 30" Built-In Single Oven I N S TA L L AT I O N OPTIONS Model WWD30 with integrated drawer front may be installed above or below any Wolf built-in oven, or below an electric or gas cooktop, provided the warming drawer is fully enclosed, top and bottom, with a minimum base support of 200 lbs (91 kg). Refer to the cooktop and oven sections for additional specifications. [. . . ] Consult a qualified HVAC engineer for specific installation and ducting applications. Blower Number IBLOWER-120INT (804703) BLOWER-110IL (808332) BLOWER-90REM (801641) BLOWER-120REM (801642) BLOWER-150REM (804701) Island Hood Models All Island Hoods All Island Hoods I363418 / I423418 / I543418 All Island Hoods All Island Hoods 1500 CFM Remote Vertical discharge with 10" (254) round duct. PRO HOOD LINERS Blower Description 600 CFM Internal* 1200 CFM Internal 1100 CFM In-Line 900 CFM Remote Blower Number Included with (I) Model LBLOWER-120INT (805087) BLOWER-110IL (808332) BLOWER-90REM (801641) BLOWER-120REM (801642) BLOWER-150REM (804701) Hood Liner Models L282212I All Hood Liners (except L282212I) All Hood Liners (except L282212I) All Hood Liners (except L282212I) All Hood Liners (except L282212I) All Hood Liners (except L282212I) Island hood models without decorative rails listed; blower options are the same for (R) models. 1200 CFM Remote 1500 CFM Remote *Vertical discharge with 8" (203) round duct. In-line blower is vertical discharge with 10" (254) round duct. Remote blowers are adjustable discharge with 10" (254) round duct. Transition with backdraft damper included with all island hoods and hood liners. 98 Dimensions in parentheses are in millimeters unless otherwise specified. WOLF APPLIANCE PRODUCTS LIMITED WARRANTY RESIDENTIAL USE ONLY FULL TWO YEAR WARRANTY* For two years from the date of original installation, your Wolf Appliance product warranty covers all parts and labor to repair or replace any part of the product that proves to be defective in materials or workmanship. All service provided by Wolf Appliance Company under the above warranty must be performed by a Wolf Appliance authorized service center, unless otherwise specified by Wolf Appliance Company. [. . . ]