User manual SUNBEAM K85KQP

[. . . ] BED6322 BeddingMan06-Just English. qxd 3/8/06 12:17 PM Page 1 HEATED PRODUCT User Manual P. N. Sleep well. TM www. sunbeam. com BED6322 BeddingMan06-Just English. qxd 3/8/06 12:17 PM Page 2 IMPORTANT INSTRUCTIONS DO NOT DESTROY Warnings and Safeguards As with all electrical products, misuse of product or failure to properly follow the instructions may cause overheating, fire or personal injury. Please read the product label and all of the instructions before using your heated product. Do not use this heated product with an infant, a child, an incapacitated or immobile person, a paraplegic, a quadriplegic, a diabetic, one insensitive to heat such as a person with poor blood circulation, or anyone who cannot clearly understand the instructions and/or operate the controls. [. . . ] CAUTION: Cord must be COMPLETELY CONNECTED. 2 Ensure that no cords are still connected and none of the wires have worn through the fabric. 3 Carefully follow all washing instructions or your heated product may shrink and possibly cause a fire hazard. · DO NOT submerge control in water. · DO NOT dry clean your heated product. Dry cleaning solvents may damage the wires. · DO NOT use bleach or cleaning fluids. · DO NOT iron your heated product. · DO NOT use mothballs or sprays of any kind. · DO NOT reconnect the heated product or use it until it is COMPLETELY dry. · DO NOT wash or put into water the power cord or any of the product's cords. Taking care of your heated product is easy and safe as long as you follow a few simple steps. Machine Washing 1 Presoak the blanket/mattress pad/throw for 15 minutes in mild soap and lukewarm water. 2 Wash in mild soap and lukewarm water on the "delicate" or "gentle" cycle in the washer for two minutes. Then gently stretch to its original size. Machine Drying Caution: Do not use commercial dryers or the dryers at your local Laundromat. They get too hot and would damage the wiring of the heated product. 1 Preheat the dryer on the "low" temperature setting for 2 minutes. 2 Place blanket/mattress pad/throw into the dryer and tumble dry for 10 minutes at a low temperature. 3 Remove the blanket/mattress pad/throw while it is still damp and gently stretch it to its original size. 4 Drape the heated product over a clothesline or a shower rod. 5 Heated product must be COMPLETELY dry before reconnecting the power plug or control plug. [. . . ] A These controls are designed to notify you in the event that a problem has been discovered by flashing the light on the control. Follow instructions on the flag tag to reset control. First, check the heated product for visual damage. If no visual damage is found, unplug the system from wall outlet. [. . . ]