User manual SUNDANCE SPA EQUIPEMENT SYSTEM

[. . . ] Changes or modifications not expressly approved by the party responsible for FCC compliance could void the user's authority to operate this equipment. 1 Important Safety instructions 1. Read all instructions before installing this spa equipment system. Danger ­ A wire terminal marked "ground" is provided within the power box (Ill. To reduce the risk of electrical shock, connect this terminal to the grounding terminal of your electrical supply panel with a continuos green insulating copper wire equivalent in size to the circuit conductors supplying this equipment, but no smaller than No. [. . . ] Supplying power which is not in accordance with these instructions will void the manufacturer's warranty. The power supplied to this equipment system must be a dedicated circuit with not other appliances or lights sharing the power provided by the circuit. 3. All electrical work must be done to National Electrical Code (NEC) and any other applicable electrical codes. 4. The electrical circuit must be installed by a qualified electrician and checked by a local building/electrical inspection authority. 5. The electrical circuit supplied for the spa must include a suitable ground fault circuit interrupter (GFCI) as required by NEC Article 680-42. 6. Determine the current, voltage and wire size required. Refer to the table titled "Power Supply Requirements" (Ill. Select wire type and size based on the power requirements and the length of electrical run per National Electrical Code requirements. (Note: When using wire larger than #6, add a junction box near the equipment system and reduce to short lengths of #8 to connect to system. ) 7. All wiring must be copper to ensure reliable connections. To gain access to the main terminal connection for the spa equipment system, remove the front cover of the control box. 9. Using a connector feed the cable through the opening provide on the bottom of the control box (Ill. Connect wires, color to color, on the terminal strip (Ill. Do not neglect to run the ground line as serious damage could result. 5 11. To provide an additional measure of safety, connect a separate #8 solid copper bonding wire between the spa equipment system current collector (grounding buss bar inside the control box--Ill. 1, item 1) and a local UL-recognized ground rod fully driven into the ground. Ill. 7. External Ground Buss Power Supply Entrance Light Terminal Strip Internal Ground Buss Control Wiring Entrance Cover Screw Ozone Check Valve 8. Main Terminal Connection 6 Power Supply Requirements The power supply required by the equipment system depends on certain variables as indicated in the table below. Note that these requirements are for the equipment system only. Power for an external electric heater, if used, must be separate from, and in addition to, the power supplied to the equipment system. For gas heaters, add the power requirements to these figures. Ill. 2 Power Supply Required For Equipment System Only Using Integral In-Line Heater? [. . . ] The wire must be protected to ensure that it cannot be accidentally disconnected or broken. Run the connector through an opening in the bottom of the control box and plug it into the JP20 connection on the Sentry circuit board (Ill. To test the remote freeze sensor, place an ice cube on it before strapping it on the pipe. Both pumps should come on within a minute or two. [. . . ]