User manual SUUNTO MARINER

[. . . ] These are identified as sail mode [SAIL], barometer mode [BARO], compass mode [COMP] and time mode [TIME] in this manual and also on the display of the instrument. This is initiated by pressing and holding the [Mode] button in for 2 seconds. the backlight will remain on for 5 seconds. Pressing the [Mode] button during this time will restart the 5 second period, continuing the backlight feature. [. . . ] At the setting desired, PRESS the [Select] button to move to the next setting. Located in the center of Field 2, the hour will begin to flash. PRESS the [+] button to scroll the hour upward or PRESS the [-] button to scroll the hour downward. At the hour desired, PRESS the [Select] button to move to the next setting. At the minutes desired, PRESS the [Mode] button to accept the changes and exit the setup program. A small bell will appear at the bottom left side in Field 2 to signify an alarm has been activated. To activate up to three alarms, please repeat steps 1-8 for the selected alarm (1, 2, or 3). The Wristop Computer stopwatch sub mode can provide split time measurement and two finish times up to 24 hours. In the TIME mode, PRESS the [Select] button twice to enter this sub mode. Field 1 displays the seconds and tenths of a second, Field 2 displays the current time, and Field 3 displays hours and minutes and to the far right "stopwatch". There are three timing modes the user can employ: · An elapsed time measurement; a split time measurement; and a two finish time measurement. Field 1 displays the day of the week the user is in; Field 2 displays the atmospheric pressure; and Field 3 displays the time and to the left the text "memory". the Outer Circumference graphically displays the atmospheric pressure where one full circle equals 100 mbars or 1 inHg. PRESS the [-] button to scroll back down in increments of one hour for the first six hours, after that increments are 6 hours. Note: Replacing the battery will not erase this information. Sea level pressure is pressure relative to sea level where as the pressure read in the main barometric display is absolute pressure in the current location. In the Barometer mode, PRESS the [Select] button three times to enter this sub mode. Field 1 displays the text "SEA"; Field 2 displays the current sea level pressure; and Field 3 displays the current time. To set the sea level pressure you have two choices either give the current sea level pressure or give the exact altitude of the location (e. PRESS the [+] button to scroll the pressure upward or PRESS the [-] button to scroll the pressure downward. At the desired pressure, PRESS the [Mode] button to accept the changes and return to the main mode or if you want use altitude to set the sea level pressure, PRESS the [Select] button. At the desired value, PRESS the [Mode] button to accept the changes and return to the main mode. [. . . ] Batteries are usually available in sport and watch shops etc. This publication and its contents are proprietary to Suunto Oy and are intended solely for the use of its clients to obtain knowledge and key information regarding the operation of Suunto products. Its contents shall not be used or distributed for any other purpose and/or otherwise communicated, disclosed or reproduced without the prior written consent of Suunto Oy. While we have taken great care to ensure that information contained in this documentation is both comprehensive and accurate, no warranty of accuracy is expressed or implied. [. . . ]