User manual SWEEX LW311

[. . . ] Choose the option "Continue Anyway". Click "Finish" to complete the installation. English version Setting up the wireless network How does it work?To create a wireless network you need a wireless router, wireless modem or WiFi access point. The wireless router, modem or access point distributes the wireless network. The name of this network, also called the SSID, is dependant on your wireless router, modem or access point and is different per type or brand. [. . . ] Ensure you have the Utility installed on your computer. Start the WPS function on the modem, router or access point. English version Right-click the "Sweex Wireless Utility" icon and choose "Open Utility". Select the WPS Setting tab and click the "PCB" button. The Sweex Wireless LAN Cardbus Adapter 300 Mbps will now search for the router, modem or access point that broadcasts a WPS signal and establishes a secured connection with it. Select "PIN" if you want to use the number range under "Pin Code" as WPS network key. The found WPS routers, modems or access points will appear under WPS AP. Under WPS profile the WPS router, modem or access point that you are connected to will appear. English version Connecting the computer to the wireless network After installing the drivers of the Sweex Wireless LAN Cardbus Adapter 300 Mbps, you can connect your wireless computer with the wireless network. We describe this procedure underneath. Windows XP At the bottom right of your screen right-click the wireless connection icon and choose "View Available Wireless Networks". In this window you can see which wireless networks your computer has detected. In our example the networks "RMA-test", "Sweex" and "BLASTER" are found. In your situation the found network will be different than this image. English version To let the computer search again for available networks, press "Refresh network list" in the left column. This way you can see the most current and recent situation. The network named "Sweex" is an unsecured network. To connect your computer to it, you do not need a security code. The network "BLASTER" does have security. To connect your computer to it you need a security code. When you do not get a list, but a message that no wireless networks can be found, check if the wireless router, modem or access point are turned on and that the distance to the wireless computer is not to far. When a message appears that the wireless connection can not be configured because an other program is managing it, turn off this software and start with the previous step. To connect to one of the found networks, select it and click on the "Connect" button. This message appears when you connect to an unsecured network. Click "Connect Anyway". This window appears when you connect to a secured network. Here you are asked for the security code. Enter the network key on both lines and click "Connect". When a successful connection has been established with the wireless network a message appears after a few moments saying "Connected". You now have a working wireless network. English version When the entered network key is incorrect a messages will pop up after a few moments telling "Limited or no connection possibilities". Now you do not have a good wireless connection. Check the wireless router, modem or access point that has to give the computer an IP-address. [. . . ] In most cases you will receive an IP-address from the wireless router or modem when the connection has been established correctly. If you can not select "Status", no connection has been made. In this case choose "Connect / Disconnect". See chapter "Connecting the computer to the wireless network". Configuring IP-address in Vista If it is needed to enter the IP-address settings or to change them, go back to the "General" tab and click the "Properties" button. Select "Internet Protocol Version 4 (TCP/IPv4)" and select "Properties". 1 English version Select that you want to obtain an IP-address automatically or enter the IP-address you want to use. [. . . ]