User manual SWEEX RO003 QUICK_START_GUIDE

[. . . ] English version RO003/RO003UK Sweex Broadband Router Important!The Setup Wizard is located on the Sweex CD-ROM. This installation procedure will show you step by step how to setup the router. If your provider can not be configured with the Setup Wizard, contact your provider for the correct settings and enter them manually. Introduction · · · · Do not expose the Sweex Broadband Router to extreme temperatures. [. . . ] Reconnect the network cable between the modem and the router via the "WAN" port of the router. The "WAN" light should light up now. Connect the router via 192. 168. 23. 1 and check your Internet connection in the status screen. Setting 2 DHCP with hostname Important: when configuring the router, always use the computer with which you were connected to the Internet prior to connecting the router. Log in to the Router (see the section "Accessing the Router" above). Left in the column, click on "Internet Provider Setup" or click on "Next". 10 English version c. Select `Dynamic IP" and click on "Next". This setting is for providers who use a DHCP connection. d. Under "Hostname" enter the hostname you received from your provider. In order to enter the MAC address of your computer into the router, click "Clone MAC". Click "Save" to save the settings. In order to check whether the Internet connection has been set up successfully, go to the status screen by clicking "Status" left in the column. The "WAN IP" section will display your Internet IP address. It can sometimes take up to 1 minute for this IP address to appear. You have now completed the configuration and are ready to surf the Internet. i. If your IP address continues to be displayed as 0. 0. 0. 0, click on "Renew". If after 1 minute your IP address still continues to show as 0. 0. 0. 0, check the above steps. Disconnect the network cable between the router and the modem at the "WAN" port. Switch on the router and wait until it is fully started up. Switch on the modem and wait until it is fully started up and all the correct lights are lit. Reconnect the network cable between the modem and the router via the "WAN" port of the router. The "WAN" light should light up now. Connect the router via 192. 168. 23. 1 and check your Internet connection in the status screen. 11 English version Setting 3 PPPoE 1. [. . . ] Click "Save" to save the settings. Log in, using your new user name and password. Upgrading the firmware of the router (Firmware) In order to provide the router with updates, the so-called `firmware' needs updating. Left in the menu, click "System Tools" and then "Firmware". 17 English version Here the firmware of the router can be upgraded. New firmware can be downloaded from the Sweex website under "Service and support". [. . . ]