User manual SWISHER BIG MOW-AZ

[. . . ] All AZ Series Models from Serial # 97-056001 Zero Turn Riding Mowers Read and follow all Safety Rules and Instructions Before Operating This Equipment Rev. 12. 01. 1997 ! CAUTION: Assembly Operation Service and Adjustment Repair Parts Made In The P. O. BOX 67, WARRENSBURG, MISSOURI 64093 PHONE 660-747-8183 FAX 660-747-8650 Manufacturing quality lawn care equipment since 1945 USA Swisher Mower & Machine Co. Box 67 Warrensburg, MO 64093 Phone (660) 747-8183 Toll Free (800) 222-8183 FAX (660) 747-8650 Dear Valued Customer: All of us at our plant in Warrensburg, Missouri, are delighted that youve chosen to purchase a Swisher Zero Turn Radius Mower. [. . . ] The engine SHOULD NOT be running as you familiarize yourself with these controls. RIGHT AND LEFT SIDES OF MOWER ARE DETERMINED BY SITTING IN THE DRIVERS SEAT. OPERATOR POSITION FRONT LEFT RIGHT REAR BE SURE TO READ THIS SECTION BEFORE STARTING THE ENGINE FOR THE FIRST TIME Check fuel and oil levels. Make sure the Drive Control and Blade Clutch Levers are pulled back and disengaged. Once engine is started, become familiar with the steering and maneuvering of the mower before engaging the blades. chain on the front wheel, is engaged when it is resting flat against the front wheel. ENGAGING THE DRIVE: The motion of the mower is controlled by the Drive Clutch Lever (AZ125) located just below the steering wheel, on the left side. Push the Drive Clutch Lever (AZ125), which is located on the left side of the steering wheel, forward. The mower will BEGIN MOVING FORWARD IN THE DIRECTION THE FRONT TIRE IS POINTED. 8 Hand-Operated/Two-speed Drive: (all models begin with AZ2) DRIVE ENGAGEMENT PIN: The Lock Pin Lever (TR148L) should always be engaged (flat against the wheel) BEFORE starting the engine. To move the mower when engine is not running, the Lock Pin Lever (TR148L) must be disengaged. Do not engage pin when engine is running. The Lock Pin Lever (TR148L), located opposite the To disengage the drive, pull the Drive Clutch Lever (AZ125) back. The lever on the right side of the steering wheel controls ground speed: Low Speed: place the lever in the lower position closest to the operator. This speed is excellent for trimming and maneuvering in tight places. High Speed: push the lever forward (away from) the operator. This speed is used for mowing large open areas. Changing from low speed to high speed or from high speed to low speed can be done without disengaging the drive. THE ZERO-TURNING RADIUS Swisher s patented front wheel drive steering mechanism provides 360 degrees of maneuverability. Reverse directions by simply turning the front wheel in the direction you want to go. To reverse directions in tight areas, pull back the Drive Control Lever (AT125) to stop the mower. Then turn the steering wheel 180 degrees (in the opposite direction). Engage the Drive Lever once again. Foot-Pedal Operated: (all models begin with AZV) To engage the drive, press your foot against the pedal. The speed of the mower is regulated by the amount of pressure against the foot pedal. The mower automatically stops and brakes when you lift your foot off the pedal. [. . . ] We will repair or replace, at our discretion, parts found to be defective due to materials or workmanship. This warranty is subject to the following limitations and exclusions: 1) Engine Warranty All engines utilized on our products have a separate warranty extended to them by the individual engine manufacturer. Any engine service difficulty is the responsibility of the engine manufacturer, and in no way is Swisher Mower Co. , Inc. or its agents responsible for the engine warranty. [. . . ]