User manual SWISHER LS67528S

[. . . ] swisherinc. com OWNER'S MANUAL MODEL NO. LS67528S LOG SPLITTER IMPORTANT Read and follow all Safety Precautions and Instructions before operating this equipment. Rev. 05-019 Safety Assembly Operation Service and Adjustment Repair Parts 1602 CORPORATE DRIVE, WARRENSBURG, MISSOURI 64093 FAX 660-747-8650 PHONE 660-747-8183 Made In The Manufacturing quality lawn care equipment since 1945 10013 USA LIMITED WARRANTY The manufacturer's warranty to the original consumer purchaser is: This product is free from defects in materials and workmanship for a period of two (2) years from the date of purchase by the original consumer purchaser. We will repair or replace, at our discretion, parts found to be defective due to materials or workmanship. [. . . ] Be aware of the extra length of splitter while turning, parking, crossing intersections, and in all driving situations. · · · · · · OPERATION INSTRUCTIONS POSI-LOCK COUPLER ADJUST COUPLER LOCKING PRESSURE ON BALL BEFORE USE. PLACE HANDLE IN LOCKED POSITION WITH BALL IN COUPLER. · TIGHTEN LOCKNUT AGAINST TENSION SPRING SO THAT COUPLER IS NOT LOOSE ON BALL. CORRECT ADJUSTMENT WILL ALLOW HANDLE TO BE RELEASED WITH MODERATE PRESSURE APPLIED TO HANDLE. TO OPEN, PULL UP ON COUPLER HANDLE AND ROTATE FORWARD. PLACE COUPLER ON BALL WHEN BALL IS COMPLETELY NESTED IN BALL SOCKET, ROTATE COUPLER HANDLE BACKWARD UNTIL HANDLE IS IN LOCKED POSITION. AFTER TOWING FOR 50 MILES, CHECK COUPLER FOR TIGHTNESS ON BALL. BE SURE COUPLER HANDLE IS IN LOCKED POSITION. WARNING: NEVER EXCEED WEIGHT CAPACITY AND ALWAYS USE SAFETY CHAINS. ALWAYS USE CORRECT BALL SIZE, MAKING SURE BALL IS COMPLETELY INSERTED INTO COUPLER. LOCK COUPLER HANDLE SECURELY BEFORE TOWING. ALWAYS CHECK FOR DAMAGES AND REPLACE IF DAMAGED. AVOID SHARP TURNS AND STEEP VERTICAL ANGLES WHEN TOWING. SAFETY DECALS Replace decals immediately if damaged. OD16 ­ FUEL SHUT OFF DECAL OD07 ­ COLD WEATHER DECAL OD12 ­ HYDRAULIC FILL PLUG DECAL OD08 ­ OPERATOR INSTRUCTION DECAL OD09 ­ DANGER/POSITION LOCK DECAL 5 OPERATION Intended use: This log splitter is intended and designed to only split wood. Doing so can cause injury or VOID THE WARRANTY. ASSEMBLY INSTRUCTIONS This log splitter has been partially assembled at the factory. Refer to the drawings and part lists should it become necessary to disassemble the unit for repair or replacement of parts. WARNING: Exercise extreme caution, as parts are very heavy. Sufficient persons or mechanical handling equipment should be used. IMPORTANT: This unit is shipped without gasoline or oil in the engine. After assembly, see separate Engine Manual for proper fuel and oil recommendations. General Assembly: Remove top, sides and ends of crate. Place crate panels aside to avoid puncturing tires. [. . . ] The wedge is heavy and may still have sharp edges, wear gloves while handling the wedge. REPAIR PARTS Your Swisher Log Splitter has been produced with components designed specifically to this machine. Although standard springs, hardware, etc. may look similar to parts used on other machinery, they may in some cases be made of a different construction and/or materials. 8 Light Kit Assembly Instructions 1. [. . . ]