User manual SWISHER LS722H

[. . . ] swisherinc. com OWNER'S MANUAL MODEL NO. LS722H STARTING SERIAL #: L206-010001 Model LS12534H Shown LS728H STARTING SERIAL #: L206-010001 LS10528H STARTING SERIAL #: L206-010001 LS12534H STARTING SERIAL #: L206-010001 LS12534H12V STARTING SERIAL #: L206-010001 LOG SPLITTER Safety Assembly Operation Service and Adjustment Repair Parts PHONE 660-747-8183 Made In The IMPORTANT Read and follow all Safety Precautions and Instructions before operating this equipment. Rev. 06-164 1602 CORPORATE DRIVE, WARRENSBURG, MISSOURI 64093 FAX 660-747-8650 Manufacturing quality lawn care equipment since 1945 12489 USA LIMITED WARRANTY The manufacturer's warranty to the original consumer purchaser is: This product is free from defects in materials and workmanship for a period of two (2) year from the date of purchase by the original consumer purchaser. We will repair or replace, at our discretion, parts found to be defective due to materials or workmanship. [. . . ] A log could easily be pushed forward into the vehicle. See tire and wheel specifications for PSI while towing. Be aware of the extra length of splitter while turning, parking, crossing intersections, and in all driving situations. · · · · · · OPERATION INSTRUCTIONS POSI-LOCK COUPLER ADJUST COUPLER LOCKING PRESSURE ON BALL BEFORE USE. PLACE HANDLE IN LOCKED POSITION WITH BALL IN COUPLER. TIGHTEN LOCKNUT AGAINST TENSION SPRING SO THAT COUPLER IS NOT LOOSE ON BALL. CORRECT ADJUSTMENT WILL ALLOW HANDLE TO BE RELEASED WITH MODERATE PRESSURE APPLIED TO HANDLE. TO OPEN, PULL UP ON COUPLER HANDLE AND ROTATE FORWARD. PLACE COUPLER ON BALL WHEN BALL IS COMPLETELY NESTED IN BALL SOCKET, ROTATE COUPLER HANDLE BACKWARD UNTIL HANDLE IS IN LOCKED POSITION. AFTER TOWING FOR 50 MILES, CHECK COUPLER FOR TIGHTNESS ON BALL. BE SURE COUPLER HANDLE IS IN LOCKED POSITION. WARNING: NEVER EXCEED WEIGHT CAPACITY AND ALWAYS USE SAFETY CHAINS. ALWAYS USE CORRECT BALL SIZE, MAKING SURE BALL IS COMPLETELY INSERTED INTO COUPLER. LOCK COUPLER HANDLE SECURELY BEFORE TOWING. ALWAYS CHECK FOR DAMAGES AND REPLACE IF DAMAGED. AVOID SHARP TURNS AND STEEP VERTICAL ANGLES WHEN TOWING. · 5 ASSEMBLY This log splitter has been partially assembled at the factory. Refer to the drawings and part lists should it become necessary to disassemble the unit for repair or replacement of parts. If you believe you have a damaged part please contact customer service immediately at 1-800-222-8183. WARNING: Exercise extreme caution, as parts are very heavy. Sufficient persons or mechanical handling equipment should be used. Refer to uncrating and assembly instructions for assembly procedures. OPERATION INTENDED USE: This log splitter is intended and designed to only split wood. Doing so can cause injury or VOID THE WARRANTY. IMPORTANT: This unit is shipped with oil but without gasoline in the engine. After assembly, see separate Engine Manual for proper fuel and oil recommendations. WARNING: DO NOT START OR RUN THE LOG SPLITTER WITHOUT OIL IN THE ENGINE AND HYDRAULIC RESERVOIR. To stop engine, move throttle lever to "SLOW" for a few seconds then to "STOP. " 6 COLD WEATHER START UP The Cold Weather Clutch enables the engine to be started without having to pull through cold, thickened hydraulic fluid. [. . . ] Check/replace solenoid Recharge or replace battery. See authorized service center. 12 Volt Units Engine will not turn over 1. Bad alternator. Engine clicks but will not start Battery will not charge NOTE: For repairs beyond those listed here, contact your nearest authorized service center. * Flushing the reservoir tank and hoses with kerosene whenever service is performed on the tank, hydraulic pump or valve is recommended. [. . . ]