User manual SWISHER LV5537S

[. . . ] swisherinc. com OWNER'S MANUAL STARTING SERIAL #: L505-160001 MODEL NO. LV5537 LV5537S LAWN VACUUM Wand Adaptor Kit sold separately. Part Number 5473 IMPORTANT Read and follow all Safety Precautions and Instructions before operating this equipment. Rev. 05-160 Assembly Operation Service and Adjustment Repair Parts PHONE 660-747Made In The 1602 CORPORATE DRIVE, WARRENSBURG, MISSOURI 64093 8183 FAX 660-747-8650 Manufacturing quality lawn care equipment since 1945 ONLV USA LIMITED WARRANTY The manufacturer's warranty to the original consumer purchaser is: This product is free from defects in materials and workmanship for a period of one (1) year from the date of purchase by the original consumer purchaser. [. . . ] Remove outside crate and set parts aside. Remove small components and identify each piece. Raise front hitch, using caution to prevent latch from being bent. Align holes in frame and install 3/8-16X1" Hex Head bolt and lock nuts. Tighten all four of the hitch bolts securely. (Figure 2) Insert hitch tube into the front of the hitch and lock in place with the snap pin (H11). Lower trailer down on the wheels and roll off of the pallet. Align fan/engine/pump assembly on lower slots of motor base with the rivets, pushing down and rearward to align the front holes. (Figure 3) Install 3/8-16X1" bolts in front holes and tighten. Unfold fabric bag frame and place into pockets at the corner of the bed. (Figure 5) Install tailgate by sliding downward into the rear channels. Open fabric bag and spread over the top frame stretching downward and slipping the plastic edge under the edge of the trailer bed rail. Attach the Velcro tabs around the rear frame section and zip the rear flap closed. Insert the bag adaptor into the bag sleeve at the front upper left hand corner Install upper tube onto blower and lock into place. Install hose onto the front of the blower housing and secure clamp. Cut boot to fit deck and install to deck. (Figure 4) Assemble end of hose and a hose clamp over the round opening of boot and tighten clamp. PREPARING THE DECK BOOT · View the boot templates that are provided. Select the template that corresponds with the discharge opening of mowing deck. If a template does not exist for your mower, then one will need to be created. · To create a custom template, mark around your discharge opening on a piece of cardboard. · Tape the template to the face of the boot, locating the template approximately ½" from the front edge and ¼" down from the top. Mark outline of template onto the face of the boot using a white crayon, nail or scribe. [. . . ] · Begin operation at low speed, adjust forward speed to match grass height and/or moisture condition to prevent clogging. Should your Lawn Vacuum become clogged, shut off tractor and vacuum engines. Before attempting to unclog, remove spark plug wire to prevent accidental starting. · To empty cart, shut off tractor engine and set brake. [. . . ]