User manual SWISHER PST67522

[. . . ] swisherinc. com OWNER'S MANUAL MODEL NO. PST67522 POSTMASTER TOW MOWER & FENCE POST TRIMMER Assembly Operation Service and Adjustment Repair Parts Rev. BOX 67, WARRENSBURG, MISSOURI 64093 PHONE (660) 747-8183 FAX (660) 747-8650 Made In The Manufacturing quality lawn care equipment since 1945 ONPM03 USA LIMITED WARRANTY The manufacturer's warranty to the original consumer purchaser is: This product is free from defects in materials and workmanship for a period of one year from the date of purchase by the original consumer purchaser. We will repair or replace, at our discretion, parts found to be defective due to materials or workmanship. [. . . ] Children are often attracted to the machine and the mowing activity. Never assume that children will remain where you last saw them. 4 SLOPE OPERATION!Use extra caution when mowing on slopes. Operate self-propelled units up and down slopes. There is a significant risk of overturns when operating across slopes. If you feel uneasy on a slope then do not mow it. The Postmaster is designed to trim along fence rows, tree rows, etc. The Postmaster has been designed to run offset to either side and also offset from the center of the tow vehicle to provide additional cutting width. STOPPING THE ENGINE · Slide the throttle into the "STOP" position. · Return unit to travel position. INSTALLING STRING (Refer to OD63- String Diagram Decal) · Use proper length string. Using a string too long for the unit will cause stalling and unacceptable operation. · Remove any built-up debris gathered in string holder. · Fold string in half, creating a balanced loop. · Place loop of string against outside of loop on trimmer head. · Bring ends around and through the loop and over the string loop. · Pull ends to tighten loop · Cut string off evenly with outside diameter of the cover to protect fence posts and other items being trimmed. OD63- String Diagram Decal STARTING THE ENGINE · Remove any built-up debris from engine. · Remove trimmer from travel rest and assemble into desired position. Note: A warm engine may not need to be primed. · Slide throttle into "FAST" position. · Adjust throttle to desired engine RPM. For maximum results, operate in the full throttle position. [. . . ] · If unit is to be stored for longer than 30 days, prepare as directed below: Drain fuel outside into an approved container. Start engine and run until unit is completely out of fuel. Removing fuel prevents gum deposits from forming inside carburetor. Gum deposits can malfunction the engine. [. . . ]