User manual SWISHER WB80042F

[. . . ] Visit us at: www. swisherinc. com OWNER'S MANUAL MODEL NO. WB80042F THE FINISHING TOUCH 42" FINISH CUT MOWER SELF PROPELLED WALK BEHIND Read and follow all Safety Rules and Instructions before operating this equipment. 12. 18. 2002 Assembly Operation Service and Adjustment Repair Parts 1602 CORPORATE DRIVE, P. O. BOX 67, WARRENSBURG, MISSOURI 64093 PHONE (660) 747-8183 FAX (660) 747-8650 Made In The Manufacturing quality lawn care equipment since 1945 ONWB842 USA SAFETY AND OPERATIONAL DECALS Replace decal immediately if damaged. [. . . ] Belt should be snug during engagement of blade latch. Too much tension will not allow the blade latch to function properly. Tighten nuts on blade engage cable when finished. Install belt cover and tighten hardware. WHEEL DRIVE BELT REPLACEMENT REMOVAL · · · · Stop engine, let all moving parts come to a complete stop. Remove Blade Drive Belt, (See "Blade Drive Belt replacement") Locate belt guide for wheel drive belt and loosen. Remove wheel drive belt. · · · · INSTALLATION Install belt as shown. Adjust belt guide snug against motor pulley and back off ¼". Install Blade Drive Belt (see "Blade Drive Belt installation"). Install belt cover and tighten hardware. · · Check for loosened bolts, nuts, springs, etc. Keep blades in good working order. Adjust Nuts WHEEL BRAKE ADJUSTMENT Adjustment may be necessary if the unit does not stay in position on a hill with the operator bails released, or if the brake drags while in neutral with the "GROUND CONTROL" bail engaged. PROCEDURE · · · · Stop engine, let all moving parts come to a complete stop. Release "GROUND CONTROL" bail. When the "GROUND CONTROL" bail is disengaged there should be constant tension on the brake arm. All tension should be off brake arm when "GROUND CONTROL" bail is engaged. Tighten adjustment nut when finished and re-attach spring, if necessary. · WHEEL DRIVE BELT ADJUSTMENT Adjustment may be necessary if loss of traction occurs due to belt slippage. PROCEDURE · · Adjust "GROUND CONTROL" cable in or out to achieve maximum traction. Too much tension will not allow the "GROUND CONTROL" bail to fully activate. Too little tension will allow the belt to slip, resulting in loss of traction. [. . . ] All cutter parts listed herein may be ordered directly from Swisher Mower & Machine Co. All engine parts may be ordered from the nearest dealer of the engine supplied with your cutter. WHEN ORDERING PARTS, PLEASE HAVE THE FOLLOWING INFORMATION AVAILABLE: * * * * PRODUCT ­ FINISHING TOUCH SERIAL NUMBER - _______________ MODEL NUMBER - _______________ ENGINE MODEL NUMBER - _______________ TYPE - _______________ * PART NUMBER * PART DESCRIPTION TELEPHONE - 1-800-222-8183 FAX - 1-660-747-8650 SWISHER MOWER & MACHINE CO. BOX 67 WARRENSBURG, MO 64093 Visit us at: www. swisherinc. com SWISHER MOWER & MACHINE CO. [. . . ]