User manual SYLVANIA ZV450SL8

[. . . ] The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. Only a qualified service person should remove the cover or attempt to service this device, due to possible eye injury. FCC WARNING- This equipment may generate or use radio frequency energy. Changes or modifications to this Equipment may cause harmful interference unless the modifications are expressly approved in the manual. [. . . ] Before recording from an external device, refer to the instructions for the connection on page 50. Turn on the TV and press [POWER], and be sure to select the input of the TV to which the unit is connected. When you want to record to the disc: Press [DVD ]. Press [OPEN/CLOSE A] again to close the disc tray. When you want to record to a cassette tape: Press [VCR ]. Insert the cassette tape with an erase-protection tab into the cassette compartment. To use the input jacks on the rear of this unit; Select "L1" by using [INPUT SELECT] or [CH K / L]. â· To use the input jacks on the front of this unit; Select "L2" by using [INPUT SELECT] or [CH K / L]. â· You can also select "L1" or "L2" by using [the Number buttons]. This operation may take awhile to be completed. You can copy a DVD to a cassette tape or copy a cassette tape to a DVD. This function will be possible only if the DVD or the cassette tape is not copy protected. Before starting this function, prepare for the recording on the DVD-RW/-R or the cassette tape. Press [SETUP] and use [K / L] to select "General Setting", then press [ENTER]. Use [K / L] to select "Recording", then press [ENTER]. Use [K / L] to select "Dubbing Mode", then press [ENTER]. Use [K / L] to select "VCR then press [ENTER]. Use [K / L] to select "DVD then press [ENTER]. Then press [PAUSE F] at the point you wish to start recording. â· Since it takes about a few seconds before the actual dubbing begins, please allow extra 5 seconds when selecting the starting point. Then press [PAUSE F] at the point you wish to start recording. Make sure to select a recording speed using [REC SPEED]. [. . . ] Type of title are capable of playing DVD players with DVD-RW recorded in VR mode. Cable/satellite box RF coaxial cable This connection is for TV loop through only Following discs are recommended for good recording quality and are proven to be compatible with this unit. However, depending on the media condition the unit may not read the disc properly. Verbatim DVD-R 8x, DVD-RW 2x JVC DVD-RW 4x Maxell DVD-R 8x/16x Performance of any other discs are not guaranteed. [. . . ]