User manual SYMPHONIC 13TR

[. . . ] Batteries should never be thrown away or incinerated but disposed of in accordance with your local regulations concerning chemical wastes. Contact your council for details. Supplied Accessories · Remote control · Two R6 (AA) batteries · Owner's Manual DECLARATION OF CONFORMITY This product complies with the requirement of the directives EMC-Directive: 89 / 336 / EEC Low Voltage Directive: 73 / 23 / EEC CE Marking: 93 / 68 / EEC We declare that the following product: LCD COLOUR TV, Model 13TR is in compliance with following Regulations. EN55013: 2001 + A1: 2003 EN55020: 2002 + A1: 2003 EN61000-3-2: 2000, EN61000-3-3: 1995 + A1: 2001 EN60065: 2002 EN60825-1: 1994 + A1: 1996 + A2: 2001 Help Phone Number in the UK : 0870 Printed in EU 383 3010 1EMN21945 L4630BA***** EN L4630BA(EN). fm Page 2 Thursday, June 15, 2006 3:42 PM PRECAUTIONS WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. . CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. [. . . ] Note: The S-VIDEO jack is given priority over the VIDEO jack. VIDEO input jack AV-IN2: Connect to the video output jack of a video camera, VCR or video game. AUDIO L/R input jacks AV-IN2: Connect to the left/right audio output jacks of a video camera, VCR or video game. Note: The AUDIO L (input) jack is for mono input. Use this jack for monaural audio equipment to be hooked up. Aerial input jack Connect to an antenna, cable system or satellite system. RGB scart jack AV-IN1: Connect to the scart jack of a DVD player or set top box. Headphone jack 25 26 27 28 29 30 Connect headphone (not supplied) for personal listening. Note: Do not connect earphones that have an L-shaped plug. The plug may interfere with the cabinet. Table Stand Tilt Stand Adjust the stand to change the angle of TV (-5°~10°). 5° 10° PREPARATION FOR USE Unpacking The stand of this TV is folded when you purchased. Place this TV facedown on a flat surface covered with the soft cloth. Bend the stand slowly to forward until it clicks. Do not bend from this side. If you want to fold the stand again, insert a thin rod into the hole in the right side of the stand as illustrated, bend the stand backward while you keep pushing the hole. Connections VHF UHF 1) Insert the RF cable plug into the VHF/UHF MIXER RF cable (not supplied) Aerial input jack at the back of this unit. When you move a channel, all the other channels in the positions will be affected. 1) Press STANDBY-ON to turn on the TV. 2) Press / (prog. ) or the Number buttons to select the TV 3) 4) 5) 6) channel which you would like to allocate the decoder to. Press SETUP so that the menu display appears on the TV screen. Press Cursor K / L to point to "INITIAL", then press ENTER . Press Cursor K / L to point to "CH TUNING", then press ENTER . Press Cursor K / L to point to "MANUAL", then press ENTER. 1) Follow the steps 1) to 4) in the "Automatic Channel Presetting". 2) Press Cursor K / L repeatedly to point to "MOVE", then press 3) Press Cursor K / L repeatedly to select the position number you want to change the channel, then press ENTER . · You cannot select a position number where "- - -" appears next to the number. This is because SKIP is set to "ON" for this position number. 4) Press Cursor K / L repeatedly to move the selected channel to the programme number you want to assign, then press ENTER . 5) Press SETUP to exit. SETUP PICTURE BACK LIGHT [BRIGHT] INITIAL INITIAL CH TUNING LANGUAGE CH TUNING AUTO MANUAL MOVE ENTER . 7) Press Cursor K / L to point to "DECODER". [. . . ] · To directly select the page numbers shown at the bottom of the TV screen, use RED/GREEN/YELLOW/CYAN. · To call up the hidden information, press REVEAL. · To hold the current page, press (hold). · To go back to the start page, press (index). [. . . ]