User manual SYMPHONIC CWF2703

[. . . ] FUNAI CORPORATION LIMITED WARRANTY FUNAI CORP. will repair this product, free of charge in CANADA in the event of defect in materials or workmanship as follows: DURATION: PARTS: LABOR: FUNAI CORP. will provide parts to replace defective parts without charge for one (1) year from the date of original retail purchase. Certain parts are excluded from this warranty. [. . . ] 12. SLEEP button- Press the SLEEP button to display the sleep timer and start the function. The shut off time can be determined by the number of times you press the button. (0, 10, 20, 30, . . 90, 0 minutes) 13. GAME button- Press to set the Game mode and external input mode at the same time. Press the GAME button again to exit this mode. 14. CHANNEL NUMBER buttons- Press two digits to directly access the desired channel. Remember to press a "0" before a single digit channel. +100 button- Press to select cable channels higher than 99. IN jack- Connect to an antenna, cable system, or satellite system. 16. AC cord- Connect to a standard AC outlet (120V/60Hz). NOTE: Unwrap the AC cord completely from the backcover before plugging the cord into an AC outlet. INSTALLING THE BATTERIES 1) Slide the battery compartment cover back on the remote unit. 2) Insert 2 "AA" penlight batteries into battery compartment in the direction as indicated by the polarity (+ / -) markings. Batteries installed with incorrect polarity may damage the remote unit. 3) Replace the cover. EXTERNAL INPUT MODE When using an external input signal (VCR or camcorder), connect the player's audio/video output cables to the AUDIO IN/ VIDEO IN jacks of your TV. For details, see "USING THE GAME BUTTON" in PICTURE ADJUSTMENT section. PREPARATION FOR USE LANGUAGE SELECTION If you want to change the language of the on-screen menu, follow the procedure below. 1) Connect the power cord to a standard AC outlet. Note: If some digits appear in the corner of the screen, press the POWER button without unplugging the power cord. 2) Press the POWER button to turn on the TV. 3) Press the MENU button so that the menu display appears on the TV screen. 4) Press the CH(annel) or button to point to "[ENGLISH]". 5) Select "ENGLISH" or "FRANÇAIS" = French by using the VOL(ume) or button. 6) Press the MENU button to exit the menu. PICTURE CHANNEL SET [ENGLISH]FRANÇAIS V-CHIP SET UP CAPTION [OFF] PICTURE CHANNEL SET [ENGLISH]FRANÇAIS V-CHIP SET UP CAPTION [OFF] 3) Press the VOL(ume) button so that "ADD/DELETE" is selected. 4) Use the CH(annel) or button to select the channel you wish to put into memory or to erase from memory. Note: The display will return to the normal screen automatically in about 10 seconds. [. . . ] Do not spray insecticide liquid near the TV. Such chemicals may cause damage and discoloration to the exposed surfaces. PROBLEM POSSIBLE REMEDY SUPPLIED ACCESSORIES Remote control unit (N0108UD or N0132UD) Batteries ("AA" x 2) Owner's Manual (0EMN02281) Owner's Manual Try a new channel, if OK, then possible station trouble. Is antenna connected to terminal on the back of the set?If outside antenna is being used, check for broken wire. [. . . ]