User manual SYMPHONIC SV206G

[. . . ] CAUTION: USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE. CAUTION: VISIBLE AND INVISIBLE LASER RADIATION WHEN OPEN AND INTERLOCK DEFEATED. LOCATION: INSIDE, NEAR THE DECK MECHANISM. FCC WARNING- This equipment may generate or use radio frequency energy. [. . . ] Then, connect the DVD /VCR power plug to a standard AC outlet. 2 Turn on the TV and set the TV to channel 3. ¡If noise appears, change the RF output channel of the VCR to channel 4 by pressing PLAY for 3 seconds during playback. Then select the same channel (CH4) on your TV. (See "RF OUTPUT CHANNEL" on page 13 for the detail. ) 2 Select "CHANNEL SET UP" by pressing K or L. Then, press B. 3 Select "AUTO SET UP" by pressing K or L. Then, press B. ¡After scanning, the tuner stops on the lowest memo- 3 Turn on the VCR by pressing POWER. the POWER light will come on. rized channel. 4 Select the On Screen Language ("ENGLISH", "FRANCAIS" or "ESPAÑOL") by pressing K or L. Then, press B. ­ 16 ­ EN 1L25 TO ADD/DELETE CHANNELS When scanning, some channels may be skipped due to a weak signal. In such cases, you can add the channels to the VCR memory manually. CLOCK SET UP VCR 1 Select main menu by pressing MENU. 1 Press MENU until the main menu appears. (If you have already set the clock, you only have to press it once. If not you have to press it twice). - MENU TIMER PROGRAMMING [OFF] AUTO REPEAT CHANNEL SET UP CLOCK SET LANGUAGE SELECT AUDIO OUT [ON] TV STEREO SAP ¡If the clock is not set, the CLOCK SET menu appears first. In this case, follow step [3]. 2 Select "CLOCK SET" by pressing K or L. Then, press B. 2 Select "CHANNEL SET UP" by pressing K or L. ¡When a tape has reached the end, the VCR will rewind the tape to the beginning, and eject the tape. INDEX SEARCH An index mark will be assigned at the beginning of each recording you made. You may skip to a specific marked point by following the steps below. 4 To stop playback, press STOP. ¡If no corresponding symbols appear on the display when you press buttons such as PLAY, RECORD, D or E, that means no cassette tape is in the VCR. Please insert a tape. 1 Press SEARCH MODE so that the Index Search menu appears. Counter Reset ¡You can reset the counter by pressing 2 Enter the number of recordings you wish to skip by pressing K or L within 30 seconds. INDEX SEARCH 03 CLEAR/C. RESET on the remote control twice. STILL/SLOW You can freeze the picture on TV screen by pressing PAUSE during playback. ¡You can advance the picture one frame at a time by pressing PAUSE during the Still mode. ¡You cannot manually adjust the tracking of a still picture. However, if the picture begins to vibrate vertically during the still mode, you can stabilize the picture by pressing SKIP/CH. (o/p) on the remote or CH-(UP/DOWN) on the VCR. ¡If the picture is distorted or rolling vertically, adjust the vertical hold control on your TV, if so equipped. ¡You can watch in the slow motion by pressing SLOW during playback or the still mode. ¡If a noise bar appears on the TV screen, you can reduce it by pressing SKIP/CH. [. . . ] If a streaky or snowy picture appears during playback, the video heads in your DVD/VCR COMBINATION UNIT may need to be cleaned. Please visit your local Audio/Video store and purchase a good quality VHS Video Head Cleaner. If a Video Head Cleaner does not solve the problem, consult our nearest Authorized Service Center. NOTES: ¡Remember to read the instructions included with the video head cleaner before use. ¡Clean video heads only when problems occur. CLEANING THE DISC LENS ¡If the player still does not perform properly when it is operated while referring to the relevant sections and to "TROUBLESHOOTING GUIDE" in this Owner's Manual, the laser optical pickup unit may be dirty. Consult your dealer or an Authorized Service Center for inspection and cleaning of the laser optical pickup unit. DISC HANDLING ¡Use discs which have the following logos on them. (Optical audio digital discs. ) Recordable ReWritable ¡Handle the discs so that fingerprints and dust do not adhere to the surfaces of the discs. ¡Always store the disc in its protective case when it is not used. Make your contribution to the environment!!! [. . . ]