User manual SYMPHONIC WF32L6

[. . . ] 32 inch Digital / Analog LCD TV Owner's Manual WF32L6 POWER INPUT SLEEP SELECT 1 4 7 SETUP 2 5 8 0 3 6 AUDIO 9 STILL SCREEN MODE ENTER BACK INFO CH RETURN VOL. MUTE CH HIGH-DEFINITION TELEVISION TO RECEIVE DIGITAL/ANALOG SIGNAL, YOU MUST CONNECT ANTENNA. IF YOU NEED ADDITIONAL ASSISTANCE WITH SET-UP OR OPERATING AFTER READING OWNER'S MANUAL, PLEASE CALL TOLL FREE 1-800-605-8453, OR VISIT OUR WEB SITE AT http://www. Symphonic. us WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The important note is located on the rear of the cabinet. THIS SYMBOL INDICATES THAT DANGEROUS VOLTAGE CONSTITUTING A RISK OF ELECTRIC SHOCK IS PRESENT WITHIN THIS UNIT. THIS SYMBOL INDICATES THAT THERE ARE IMPORTANT OPERATING AND MAINTENANCE INSTRUCTIONS IN THE LITERATURE ACCOMPANYING THE APPLIANCE. IMPORTANT SAFEGUARDS 1. READ INSTRUCTIONS - All the safety and operating instructions should be read before the appliance is operated. [. . . ] 1) When using VIDEO1 or S-VIDEO1 input jack Video1 480i SD TV-PG DLSV CC 1 4 7 SETUP 2 5 8 0 3 6 AUDIO 9 STILL SCREEN MODE 2) When using VIDEO2 or S-VIDEO2 input jack Video2 480i SD ENTER BACK INFO TV-PG DLSV CC CH RETURN VOL. MUTE CH 3) When using COMPONENT1 input jacks 1 Switch the input mode. · When you press [INPUT SELECT] or [CH K/L] on the remote control, the input mode will be switched as below. TV/DTV channel Video1 Video2 Component1 5) When using HDMI IN jack Component2 Component1 1080i HD NONE 4) When using COMPONENT2 input jacks Component2 1080i HD NONE HDMI HDMI : press [CH K] 1080i HD 16:9 NONE · To use the VIDEO1 or S-VIDEO1 input jack on the TV, select "Video1". · To use the VIDEO2 or S-VIDEO2 input jack on the TV, select "Video2". · To use the COMPONENT1 input jacks on the TV, select "Component1". · To use the COMPONENT2 input jacks on the TV, select "Component2". · To use the HDMI IN jack on the TV, select "HDMI". · The information display will automatically disappear in one minute. 20 EN CHANGING THE SCREEN DISPLAY MODE Each 4 types of display mode can be selected in the screen mode in both 4:3 and 16:9 TV aspect ratio. You can select your favorite screen mode and enjoy the program. AUDIO 1 Switch the Screen mode. · Every time you press [SCREEN MODE], the TV aspect ratio will be switched alternately. 2 7 SETUP 8 0 9 STILL To press [SCREEN MODE] repeatedly until the normal screen displays. NOTE: · You may not switch the display mode depending on the program. SCREEN MODE ENTER BACK INFO When the broadcast is sending 4:3 video signal. . . When the broadcast is sending 16:9 video signal. . . Sidebar (normal) Full Full (normal) Zoom Wide Cinema Expand Cinema [Sidebar] Sidebar will display a 4:3 picture at its standard 4:3 size. Sidebars will be displayed on the right and left edges of the screen. [Full] Full will display a 4:3 picture at a 16:9 size, with horizontal elongation necessary to fill the screen. [Cinema] Cinema will display a 4:3 picture at a 16:9 size, with less horizontal elongation necessary to fill the screen because a little bit of the top and bottom edge of the screen will be cut off. [Wide] Wide will display the center of the picture as original size and the either side of the picture will be elongation. The size of the picture will depend on the original signal. [Full] A picture will be displayed at 16:9 size as it is. [Zoom] Zoom will display a 16:9 picture without changing its horizontal to vertical ratio, at its maximum size. [Cinema] Cinema will display a 16:9 picture with vertical elongation. [Expand] Expand will display a 16:9 picture with horizontal elongation. 21 EN WATCHING TV SCREEN INFORMATION You can display the currently selected channel number or other information such as the audio mode on the screen for checking. AUDIO DTV In the digital mode, the detailed information for the currently selected channel such as the Program guide is displayed. 7 SETUP 8 0 9 STILL 1 Display the detailed information for the channel. · Press [INFO] on the remote control. The currently selected program details are displayed on the screen. · The following information is displayed. (1) Program title (2) Broadcast station (3) Program guide (max. [. . . ] · If there is a discrepancy between languages, the default language will be English. 35 EN MISCELLANEOUS / SPECIFICATIONS 5°C to 40°C (41°F to 104°F) Power requirements: AC120V, 60Hz Power consumption (Maximum): 160W LCD: 32" wide XGA panel (1, 366 x 768 pixels) Dimensions: <Without stand> H : 23-7/16" (595mm) W: 32-3/16" (818mm) D : 4-9/16" (115mm) <With stand> H : 25-3/8" (644mm) W: 32-3/16" (818mm) D : 10-13/16" (275mm) Weight: 30. 4 lbs. (13. 8kg) FUNAI CORPORATION LIMITED WARRANTY FUNAI CORP. will repair this product, free of charge in the USA in the event of defect in materials or workmanship as follows: DURATION: PARTS: LABOR: FUNAI CORP. will provide parts to replace defective parts without charge for one (1) year from the date of original retail purchase. [. . . ]