User manual SYNQ AUDIO RESEARCH SMP 8.2 V1.0

[. . . ] Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. To take full advantage of all possibilities, please read these operating instructions very carefully. CAUTION: To reduce the risk of electric shock, do not remove the top cover. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. [. . . ] This is a global name for inputs with a level between 750mV and 2V. If you are using stereo channels, the signals from the L and R channels are mixed and send to the AUX bus. the AUX controls are switched as pré fader. Pré-fader aux outputs are not influenced by the position of the channel fader and are mainly used to control stage monitors. This knob controls the level of the signals sent to the EFX bus (to the EFX SEND jack on the front panel and to the internal effect module). The channel signals mixed by this bus have their overall level set by the EFX SEND Control. Since this control is placed after the channel fader, the signal level will be affected by the channel fader's setting. PAN /BAL CONTROL PAN (Mono Channel) This control pans the channel signal across the master L and R busses, thus determining the perceived position of the sound from that channel in the output stereo sound field. If a PAN control is set all the way to the left, for example, the sound from that channel will be heard from the left speaker system only. If it is set all the way to the right, the sound will be heard from the right speaker system only. Intermediate settings will cause the sound to appear at corresponding locations in the stereo sound field. bALANCE (Stereo Channel) This control adjusts the balance or the L/R position of the stereo input signal. Turning the BALANCE control to the left of center moves the apparent source toward the MAIN MIX L bus, turning it to the right moves the source toward the MAIN MIX R bus. It determines the level of the signal that is sent from the channel to the master mixing effect bus. It is the settings of the input channel volume knobs that determine the mix, or the balance of sound levels between the instruments or other sources connected to the inputs. When a channel is not being used, its volume knob should be set at the minimum position to prevent the addition of unwanted noise to the main program signal. PEAK LED INDICATOR This LED indicator shows the level of the signal input of the channel. The peak indicator lights up when the input signal reaches 5dB below the channel's clipping point. This indicator shows the level of the Post-EQ/ pre-fader signal. If the PEAK indicator lights more than briefly on high-level transients, you should use the TRIM control to decrease the input sensitivity of the channel. If this does not work, reduce the output level of the connected source. TRIM CONTROL According to the level of the input signal, use this knob to adjust the input to an appropriate level. [. . . ] Getting Started with MAC OS X Connect the mixer to your mac by using a standard USB cable. To use the mixer as your default input/output device (for system sounds and audio recording software), ensure that it is set for playback and recording in the Audio tab. You may notice that the Volume slider sets itself to the highest level. This will allow you to use the level controls of the mixer at their full range. [. . . ]