User manual SYSTEM AUDIO SUBELECTRO 200 2010

[. . . ] 14 Programming and changing the water hardness level. 14 Setting the water hardness level selector in the wash cabinet. 15 Checking the programmed water hardness . 29 2 Contents Operating the dishwasher . [. . . ] ^ Place small spoons into the slots on either side of the cutlery basket. 26 Loading the dishwasher Spoon racks For the best cleaning of heavily soiled spoons, use the supplied spoon racks to raise them above the other cutlery for better water coverage. ^ Insert spoons into every other slot with the handles pointed down. ^ A spoon rack can be clipped onto the front or back of the cutlery basket. To remove the racks: ^ Press in the locking tabs (use a spoon handle if necessary) and pull the racks up and out of the basket. 27 Loading the dishwasher Dishwashers with a cutlery tray (SC) To make unloading easier, cutlery can be grouped in zones, one for knives, one for forks, etc. Place the blades of knives and the tines of forks between the holders. Spoons should be placed in the opposite direction with handles between the holders. Longer items such as soup ladles, spatulas, mixing spoons and long knives should be placed lengthwise in the indentation in the middle of the cutlery tray. The upper spray arm must not be blocked by large items. The cutlery tray insert is removable. Spoon heads should be placed so that water can run off freely. If the spoon handles do not fit between the holders then position them like the forks and knives. 28 Loading the dishwasher Items not suitable for dishwashers: ­ Cutlery with wooden handles. ­ Glued items such as old knives with handles that are glued together around the shank of the blade. ­ Hand made craft items, antique or decorative glassware. ­ Plastic items that are not heat resistant. Please note: ­ Silver or aluminum items may tarnish. In most cases the "Light Wash", the "Normal" or the "Sani Wash" program will give excellent results. Available programs and their applications are listed in the Program Chart. 31 Operating the dishwasher Turning on the dishwasher ^ Check that spray arms are not blocked. ^ Press the "On/Off" button (14) . The "Start" indicator (16) lights. If a program is ended prematurely, important program steps (e. g. reactivating the water softener) may be omitted. Program sequence indicators (15) The "Rinse" indicator lights during the Prewash, Main wash, Interim rinse and Final rinse cycles. The "Drying" indicator lights during the drying cycle. The "End" indicator lights, when a program has finished. Starting a program ^ When selecting a program, refer to the Program chart of the operating instructions. ^ Turn the program selector (17) clockwise or counterclockwise to the selected program. ^ Press the "Start" button (16). The "Start" indicator (16) goes out and the "Rinse" (15) indicator lights. 32 Operating the dishwasher At the end of a program When a program has finished the "End" sequence indicator will light. [. . . ] The modified intake time is now stored. 49 Solving problems Cleaning the drain pump and non-return valve Use caution when cleaning the filters, non-return valve or drain pump; glass or bone splinters may be caught in the bottom of the wash cabinet. If the dishwasher is not completely drained at the end of a program, the drain pump or non-return valve may be blocked. To clean them: ^ Remove the combination filter. ^ Use a jug or bowl to scoop water out of the wash cabinet. [. . . ]