User manual T-FAL 1824

[. . . ] Wrap cord loosely around iron when storing. 1Always disconnect iron from electrical outlet when filling with water or emptying and when not in use. 1Do not operate iron with a damaged cord or if the iron has been dropped or damaged. To avoid the risk of electric shock, do not disassemble the iron. [. . . ] The types of water indicated below contain organic or mineral elements which may eventually cause spitting, brown stains or wear your iron out prematurely: pure demineralised water, water from clothes driers, perfumed water, softened water, water from refrigerators, battery water, water from air conditioners, distilled water or rain water. 2- Open the flap of the reservoir, place the iron on a table, as shown in the diagram below, and then fill it. You should not fill the tank beyond the MAX level. Wait for the light to go off and come again before you start ironing. SThe first time the appliance is used, there may be fumes and smell but this is Not harmful, will not affect use and will disappear rapidly. Cotton algodòn which respondwbest tolana higher temperatures (· The thermostat, wait until the light comes on again before ironing. If you iron a fabric made of a blend of fibres: set the temperature for the most fragile fibre. Your iron will only produce steam when the thermostat control is in the min. It is not advisable to use steam on silk or synthetics. The supply of water is cut off automatically to avoid any drips from the max. soleplate when the temperature of the iron islin insufficient to produce linen cotton coton steam. When first using the min iron, wait for 2 minuteslaine steam to be produced. Burst of Steam button ( ) 2 and move the iron from top to bottom 3 the 4 Hold the iron a few centimetres from the garment to avoid burning delicate fabrics. The electronic system cuts the power off and the auto-off warning light flashes if the iron is left vertically on the heel for more than 8 minutes or for more mthan 30 seconds if left horizontal. To restart the iron, shake it gently untiln the warning light stops flashing. When the auto-off safety feature cuts in, it is normal for the thermostat light to be off. 2 You can start ironing when the indicator light comes on for the second time. When the soleplate is cool, clean with a damp, non-metal washing up pad. Linen lin We recommend that: when using starch, it should be sprayed onto the cotton coton reverse side of the fabric and wool soleplate cleaned more frequently. Clean the anti-calc valve (at least once every 2 months) 1 Empty the iron and put the ironing control onto DRY ( ) 2 To remove the anti-calc valve, pull upwards by means of the grips located on either side. 1 Fill the tank to the MAX mark (see our recommendations on the type of water to use) 2 Put the thermostat control on MAX and the steam control on DRY ( ) 1 3 Place the iron on its heel and wait until the light goes out. Linen lin 4 Wind the cord around cotton heel and fix the coton wo the clip onto the cord 2 silkol laine soie synthetic synth. [. . . ] Wait until the thermostat indicator light goes out before using the steam. Iron put away with water in the tank and the cursor on the steam position . Empty the tank and put the iron away vertically, standing on its heel. You are using chemical descaler products or pure demineralised water . [. . . ]