User manual T-FAL STAINLESS STEEL COOKWARE

[. . . ] 1 Do not allow cord to touch hot surfaces. let iron cool completely before putting away. Loop cord loosely around iron when storing. 1 Always disconnect iron from electrical outlet when filling with water or emptying and when not in use. [. . . ] However, due to the natural minerals found in tap water, it is recommended that you clean the iron once a month using the self cleaning method on page 5. Never use any of the following water types as this may cause spitting, brown staining or premature aging of your iron: 100% purified water (bottled water), water from tumble dryers, scented water, softened water, water from refrigerators, water from batteries, water from air conditioners, distilled water, rain water, boiled or filtered water, etc. The integrated anti-scale system (depending on model) prolongs the life of the iron and provides a better ironing quality by ensuring a constant flow of steam. Use To fill the water tank Unplug your iron before filling it and set the steam control lever to (fig. 2), place the iron in a horizontal position and fill it with water (fig. Do not exceed the "MAX" fill level as indicated on the water tank of the iron. Your iron is equipped with the Easycord system to prevent the cord from dragging across your garments and wrinkling just ironed clothing. You can now plug in your appliance and begin ironing. When the iron is plugged in, the temperature control light will remain "on" until the temperature is reached (fig. Your iron heats up quickly, therefore, begin ironing with fabrics that are ironed at lower temperatures first, then go on to those requiring a higher temperature. - It is normal for the temperature indicator light to turn on and off during ironing. clean the anti-scale valve as noted below: · Unplug your iron and empty the water tank. Rinse the valve under running water and put the anti-scale valve back. It is recommended that you clean the iron once a month to slow down scale build up and prolong the life of the iron. Clean your iron as noted below: and fill the water tank to MAX. Place the iron on its heel, set the temperature dial to MAX, plug in the iron and wait for the indicator light to go out. Gently shake the iron over the sink until all of the water (along with impurities) runs out through the soleplate. ⷠAt the end of the operation, put the anti-scale valve back into the iron and allow it to heat for 2 minutes on its heel to dry the soleplate. When the soleplate is slightly warm, wipe it with a soft cloth. POSSIBLE CAUSE The chosen temperature is too low and does not allow for the formation of steam. You are using steam while the iron is not hot enough. You are using the Burst of Steam button too often. [. . . ] Always spray starch onto the reverse side of the fabric to be ironed. Please contact our consumer service department at 1-800-395-8325. The soleplate is dirty or brown and is staining the fabric. Your iron has been used dry for too long. [. . . ]