User manual T-FAL ULTRAGLIDE

[. . . ] let iron cool completely before putting away. Wrap cord loosely around iron when storing. 1Always disconnect iron from electrical outlet when filling with water or emptying and when not in use. 1Do not operate iron with a damaged cord or if the iron has been dropped or damaged. [. . . ] Turn off the steam when ironing silk or synthetic fabrics. What temperature and which steam setting to use ?- When steam or dry ironing, press several times on the Spray Button to moisten fabrics (H) and to remove stubborn creases. - Make sure that there is water in the reservoir before using this feature. Your iron heats up quickly: begin by ironing fabrics that require a low temperature, then go on to those requiring a higher temperature; · If you reduce the temperature, wait until the indicator light comes back on before ironing again. ⷠWhen ironing fabrics with mixed fibres, set the temperature to the most delicate of the fibers. - Wait a few seconds before pressing the button again. - Press the Burst of Steam button ( ) repeatedly (K), moving the iron from top to bottom (L). - Hold the iron a few inches from the fabric to avoid burning delicate fabrics. Auto Shut off security feature (depending on the model) - The electronic system automatically cuts off the electric power and the Auto Shut off indicator light blinks if the iron remains immobile on its heel for more than 8 minutes, or in a horizontal position for more than 30 seconds. - To restart the iron, just shake it gently until the indicator light stops blinking. Note : When the Auto Shut off security feature is on, it is normal that the thermostat indicator light to be off. - You may start ironing when the indicator light goes out. Unplug your iron and let it cool off before cleaning. ⷠCLEANING THE ANTI-SCALE VALVE (Once per month) : - Unplug your iron and empty the water reservoir through open filling drawer. - To remove the anti-scale valve, pull it up using the handles located on each side (N). Soak the valve in a cup of white vinegar or plain lemon juice for 4 hours (O). USING THE SELF-CLEANING METHOD In order to reduce scale build-up and extend the life of your iron, use the Self-Cleaning method once per month. You shall leave the drawer open until you have finished the cleaning process. - Place your iron on its heel and set the thermostat control on MAX. - Plug in your iron and wait until the indicator light goes out. - Shake the iron gently, over the sink, until all of the water in the water reservoir (with the impurities) has flowed out via the soleplate. [. . . ] The sole plate is dirty or brown and and is staining the fabric. ⷠYou are using too high a temperature. ⷠYour fabric is not rinsed sufficiently or you are using starch. ⷠThere is little or no steam. [. . . ]