User manual TALLY 9045N

[. . . ] This manual is protected by United States Copyright Law, and may not be copied, reproduced, transmitted or distributed, in whole or part, without the express prior written permission. Copyright Notice © 1999, NETsilicon, Inc. , DPI Imaging Division, Waltham, MA 02452. Printed in the United States of America. All rights reserved. Trademarks · AppleTalk is a trademark of Apple Computer, Inc. · Ethernet is a registered trademark of Xerox Corporation. [. . . ] At this point, you should see an entry for your Windows lpr Spooler's printer in the "Available ports" listing. For example, C:\SPOOL\PRINTER_NAME. 7. 1. 2 Microsoft Windows 95/98 Windows 95/98 comes with a TCP/IP stack. To print with this protocol, a client also requires an lpr utility. This program is available from various sources. The lpr queue can be created on each workstation or the lpr queue can be created on one workstation and shared on the network. Windows 95/98 workstations can also share a lpr printer installed on an Windows NT server on the network. The following instructions are based on the a shareware lpr application that is available from various sources, including the Print Server Card manufacturer. You will need the wlprs41. zip and wlprspl. txt for the lpr. If you wish to use the Bootp Lite program, you will also need the BOOTPL32. EXE and file provided with this Print Server Card in the BOOTP directory of the CD ROM. 7. 1. 2. 1 Loading the lpr Spooler The Windows lpr Spooler Version 4. 1 - User's Guide (wlprspl. txt) provides detailed instructions for decompressing and installing the shareware lpr spooler. 7. 1. 2. 2 Setting up the Print Server Card The Print Server Card must be given IP address and routing information to be used with TCP/IP. Note: The Print Server Card issues the BOOTP request for a finite period of time. The print server must be freshly reset for this program to work. From Program Manager under File, select Run BOOTPL32. exe. Pull down the Admin menu to Configure option. Enter the IP address that you want to assign to the Print Server Card, its Subnet Mask (make sure it matches what you are using on your subnet), Default Gateway (your router's IP address), and the MAC address of the Print Server Card (Hardware Address, listed on the Status sheet as Ethernet Address). Use colons as delimiters as shown on the status sheet rather than the dashes Windows uses. The Print Server Card should recycle and produce a status sheet showing the IP parameters you have just entered. You should get a message back stating that the Unit is Active. If you do not get this message, verify that TCP/IP is enabled on the status sheet. When you get a response that your unit is active, you should be able to ping and Telnet to the Print Server Card. 7. 1. 2. 5 Setting up IP and lpr Parameters The Print Server Card provides for a setup connection via the standard Telnet port. [. . . ] Stored values are: ENABLED DISABLED Note that this function may not be supported in all units And therefore may not be in effect even if it is 'enabled'. " ::= { dpitcp 21 } enAttachPrnt OBJECT-TYPE SYNTAX DisplayString (SIZE(0. . 8)) ACCESS read-write STATUS mandatory DESCRIPTION "This variable specifies whether or not the print of attachments to email function is enabled. Writable Values are: enabled disabled in upper case or lower case. Stored values are: ENABLED DISABLED NIC MIB Definition-25 Note that this function may not be supported in all units And therefore may not be in effect even if it is 'enabled'. [. . . ]