User manual TALLYGENICOM 9050N

[. . . ] 9050N Laser Printer User Manual Trademarks The following are trademarks or registered trademarks of their respective owners. Other product names mentioned in this manual may also be trademarks or registered trademarks of their respective owners. Registered trademarks are registered in the United States Patent and Trademark Office; some trademarks may also be registered in other countries. TallyGenicom, is registered trademarks of TallyGenicom. [. . . ] The printer supports multiple protocols. As a result, one printer can be shared even from different network environments. Supported OS and Environment Connection Port Protocol OS Windows 95 Windows 98 Windows Me Windows NT 4. 0 Windows 2000 Windows XP Windows Vista Windows Server 2003 UNIX Macintosh Network Lpd Tcp/ip X X X X X X X X X X X X X X X X X Port 9100 Tcp/ip X X X Ethertalk Appletalk In this Chapter. . . · Supported Environment · Configuration · Printer Setup Using The EWS · Printing From Unix · Printing From A Macintosh Computer · SNMP Support · Precautions And Limitations UNIX Filter are required to print PostScript data. UNIX Filter is compatible with the OSs in Solaris, HPUX and Linux (Redhat, SuSE). Macintosh Supports Mac OS 10. 02 or later. NOTE: Important:The EtherTalk port setting in this printer is disabled by default. To use this port, enable the setting on the Operator Panel. 5-1 CONFIGURATION Networking CONFIGURATION The 9050 is a fast 100BASE-TX/10BASE-T network capable printer. It supports major protocols such as TCP/IP and Ethertalk. This section details configuring the printer's network interface and should be done prior to configuring your computer. IP ADDRESS The factory configuration is for the printer to obtain an IP address automatically from your networks' DHCP server. Use the printers' Operator Panel to determine the printers' address. · · · · If the DHCP server is not available or not in use, use one of the following methods to retrieve and set the IP address. Set the IP address manually from the Operator panel or EWS Depending on the network environment, you may need to set the subnet mask and gateway address. Please check with your network administrator if you have any questions concerning your network environment. PRINTER SETUP USING THE EWS If the printer is connected to the network using TCP/IP, its settings can be configured using the EWS. The following explanation uses Windows XP and Internet Explorer version 6. 0 as an example to manually set the printers IP address. Launch the EWS using the IP address for the printer you are configuring. Select the Printer Settings Interface menu. Select the Printer's web page again. Select Printer Setup interface and change the Network 1 Setup 7. Set the IP address, subnet mask, an default gateway to the required values. Once the new address is submitted to the printer, the new address will have to be entered into the browsers' address. Most of the printers' configuration can be done through the browser including setting the administrator password. 5-2 User Manual PRINTER SETUP USING THE EWS Networking PRINTING FROM A WINDOWS COMPUTER This chapter provides guidelines on how to print over the network from various Microsoft Windows platforms. There are numerous ways of printing from Windows and the exact set-up will vary depending upon your environment. [. . . ] Default Setting English 00020 00000 10 min 60 min On Off Stop Off N/A Quality Menu The Quality Menu provides access to the printer settings that are related to print quality. Submenus Toner Saver Resolution This submenu allows you to set the resolution (dpi). Print Density Default Setting Off 600 dpi 4 A-6 User Manual Functions Menu Operator Panel Functions Menu The following submenus are a series of executable commands . Command Print Usage Rep Reset Print Demo Print Summary Print Test Print Fonts Print Error Log Definition Prints the usage report. Prints the configuration summary (same as pressing the Info button) Prints a test page. Prints the error log. Date/Time Menu NOTE: This menu selection will only appear if the Real Time Clock Option has been installed. [. . . ]