User manual TANDBERG 2U AUTOLOADER QUICK START GUIDE

[. . . ] Using scissors, a utility knife, or other appropriate tool, carefully cut the packing tape along the length and ends of the carton. Remove the accessories box from the shipping carton and check the contents. The accessories box contains the following items: · SCSI cable and terminator · Manual CD & Quick Start Guide (Hardcopy) · Power cord (EU & US version) If this is a rackmount installation, check the rack kit contents (has to be purchased separately). [. . . ] If the Autoloader is the last device on the SCSI bus (or the only device), attach a SCSI terminator to the other SCSI connector on the back panel of the Autoloader. If the Autoloader is not the last device of the SCSI bus, attach a SCSI cable from the open connector on the back panel of the Autoloader to the next device on the bus. Connect a power cord from the back panel of the Autoloader to a grounded power source. Step 5: Prepare the Host If necessary, install a SCSI host bus adapter, software, and a compatible driver on the host computer. Connect the SCSI bus to the host computer. 3 Rev. 1. 0, June 2004 Step 6: Turn on the Autoloader Turn on the Autoloader by pressing the power button on the front panel. Power on the host and all attached SCSI devices. Use the eraser end of a pencil or something similar to press the left side of the power switch. Step 6: Operating the Autoloader The following sections provide an overview of Autoloader operations. Load tapes into the Autoloader by using the Import command from the front panel and then inserting the data cartridge into the mailslot. Install data cartridges in slots 1-8: 1. Place cartridge in the cartridge access port. Press any button on the operator panel to change to interaction mode. Choose the "Commands" menu and press <Enter>. Choose "Import", press <Enter>. Enter the number of the cartridge slot and press <Enter>. The cartridge is placed in the chosen slot. 4 Rev. Repeat step 4 to 7, until all cartridges are imported. Unload tape cartridges from the Autoloader by using the Export command from the front panel. [. . . ] 1. 0, June 2004 SUPPORT CONTACT INFORMATION: Europe TANDBERG Data GmbH Feldstr. 81 D-44141 Dortmund Germany Phone: Fax: USA 0049 ­ (0)231 ­ 5436 142 0049 ­ (0)231 ­ 5436 143 INOSTOR Inc. (A TANDBERG DATA COMPANY) 13000 Gregg Street Poway CA 92064 USA Phone: Fax: 001 ­ (0)858 ­ 726 0277 001 ­ (0)858 ­ 726 0278 ASIA TANDBERG Data Pte. [. . . ]