User manual TANDBERG STORAGELIBRARY

[. . . ] Copyright © 2006 Tandberg Data ASA The information contained in this document is subject to change without notice. This document contains proprietary information which is protected by copyright. No part of this document may be reproduced, modified, distributed, or translated to another language without prior written consent of Tandberg Data. Tandberg Data ASA Kjelsåsveien 161 P. O. [. . . ] The Date & Time is configured during the Setup Wizard. After the initial setup of your library you can later access the Date & Time configuration screens directly: From the remote management interface, select Setup > Library From the front panel, select Setup > Library 38 Configuring the Library Configuring Barcode Scan This feature allows the operator to enable or disable the barcode scanner from the front panel interface or the remote management interface. The default for the library is barcode scanner enabled. If disabled, the library is forced to initialize slots by touch. The Barcode Scan is configured during the Setup Wizard. After the initial setup of your library you can later access the Barcode Scan configuration screens directly: From the remote management interface, select Setup > Library From the front panel, select Setup > Library Configuring Audible Alarm The library is equipped with an audible alarm that is activated at certain error conditions. The alarm can be enabled/disabled from the front panel interface or the remote management interface. The default for the library is audible alarm disabled. The Audible Alarm is configured during the Setup Wizard. After the initial setup of your library you can later access the Audible Alarm configuration screens directly: From the remote management interface, select Setup > Library From the front panel, select Setup > Library Configuring SNMP The library supports system monitoring via SNMP and SNMP Notifications. To enable SNMP the remote management interface must be running. To enable SNMP notifications you need to register the IP address of the notification recipient (host). The library ignores all SNMP SET operations, so external management applications cannot register themselves to receive SNMP traps from the library. The SNMP notification screen lets you manually register an external application. SNMP notification can only be set up by the Administrator from the remote management interface. The user needs to register the IP address of the notification recipient in the empty IP address field displayed on the screen. If you want to disable SNMP notifications enter 0. 0. 0. 0 in the IP address field. Note that this disables notification only. The library will continue to process SNMP Get requests as long as the RMI is enabled. Note You need to install the appropriate MIB for your FW version on the host on which the SNMP manager is running. The path to open the appropriate screen is: From the remote management interface, select Setup > Notification Configuring E-mail Notification The library can be configured to automatically send e-mail notifications to a specified e-mail address whenever an issue of a particular severity level occurs with one of its components. StorageLibrary T40 Installation and User Guide 39 The information in the e-mail notification provides a RAS ticket, a short problem description and a possible cause which may be of help to you or a customer service engineer. Before you can configure e-mail notifications, you must configure the library's e-mail account so that the library can send notifications to the designated recipient. There are three filter levels of e-mail notifications: Low - An error has occurred in the library, but the library is not in danger of failing. E-mail accounts configured with a Low filter setting receive notification of all priority levels of RAS tickets that the library produces Medium - The library is not in immediate danger of failing, but current problems could lead to a failure in the future. [. . . ] Turn off the power switch on the rear of the unit 6. The screws fasten the robotics to the front chassis. The locking screws are screwed into the robotics from the front of the library, two on each side of the front bezel. See Figure 24 Magazine Lock Marked with Red Plastic Tab 7. [. . . ]