User manual TANDBERG T48

[. . . ] Install the library in an environment compatible with this temperature limit. Ensure that the work area is free from conditions that could cause electrostatic discharge (ESD). Discharge static electricity from your body by touching a known grounded surface, such as a computer's metal chassis. [. . . ] Keep the screws loose so that you can adjust the length of the assembled rail, if necessary. Left-side rails (viewed from front) Back flange Back section Small back flange (attach the library here in final step) Front section Front flange M5 screw (black) Figure 1 Assembling the left-side rail 2 OF 8 4. Assemble the right-side rail in the same way (see Figure 2). Right-side rails (viewed from the back) Front flange Front section Back section Back flange M5 screws (black) Figure 2 Assembling the right-side rail ATTACHING THE RAILS TO THE RACK 1. Left side rail assembly--Position the left-side rail assembly in the rack so that the front flange is behind the front screw holes in the rack (see Figure 3). Back of Rack Rack rail (back) Depth of rack (E) M5 screw (A) (black) Back flange (D) Rack rail (front) Level Front rack screw holes (B) M5 screw (A) (black) Front of Rack Front flange (C) Figure 3 Attaching the left-side rail to the rack 3 OF 8 2. Front of rack--Insert an M5 screw (A) through one of the front rack screw holes (B) and engage the pem nut in the rail flange (C). If your rack has square mounting holes or the holes are much larger than the screws provided in the kit, use a washer. Insert an M5 screw (A) through a second screw hole (B) and engage the pem nut on the second screw hole in the rail flange (C). Adjust the length of the rail assembly as necessary to fit the depth of the rack (E). Back of rack--Make sure the rail assembly is level, then use M5 screws (A) to attach the back flange (D) of the rail to the inside of the rack, using the same procedure as step 2. If your rack has square mounting holes or the holes are much larger than the screws provided in the kit, use a washer. Using a #2 Phillips screwdriver, tighten the screws securing the rails to the front and back of the rack. Using a #2 Phillips screwdriver, tighten the four screws holding the rail assembly together. Right side rail assembly--Repeat steps 1 through 6 for the right-side rail assembly. Make sure that the right rail assembly is at the same level as the left rail assembly. ATTACHING THE LIBRARY TO THE RAILS To attach the library to the rails: 1. From the front of the rack, place the library onto the shelf created by the rails. Tandberg StorageLibrary T24 Weight Warning-- Warning The library weighs 43 pounds (19. 5 kg). Two people are needed to move or lift the library. Most of the weight is toward the back of the library. Die Library wiegt 19. 5 kg Es sind mindestens 2 Personen erforderlich, um die Library zu bewegen oder zu heben. [. . . ] Remove the shipping key from the library. Carefully slide the library all the way back until it makes contact with the small flanges at the back of the rails (see Figure 7 and Figure 7). From the back of the rack, attach the library to the rails by inserting an M3 (the two smaller screws) screw into each of the small flanges. [. . . ]