User manual TAPCO LINKUSB

[. . . ] Install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Only use attachments/accessories specified by the manufacturer. Unplug this apparatus during lightning storms or when unused for long periods of time. [. . . ] INPUT GAIN Control These knobs adjust the analog gain of the input signal (before the A/D converters). They adjust the signal for both the mic and line inputs. Turn the knob fully counter-clockwise to turn the signal off, and fully clockwise to get the maximum gain. 2. LINE/INSTR Switch If you are using a normal line-level input, leave this switch out. If you are connecting an instrument like a guitar directly to the Link. USB, push this switch in. It adjusts the input impedance of the 1/4" input to match the high-output impedance of a guitar pickup. 3. MIX Control This knob adjusts the signal going to your headphones and monitor out. It allows you to blend the direct input signal with the USB signal coming from your computer. In the fully counter-clockwise position, only the USB signal is present in the headphones and monitors. As the MIX knob is rotated clockwise, the input signal is added to the mix. 4. MON LEVEL Control This adjusts the level of the rear panel MONITOR analog outputs. It does not affect the headphone output. Note: Leave this knob turned down each time you turn on your system, and then increase it to a safe listening volume. 7 LINK. usb INPUT 2 X 2 USB AUDIO INTERFACE 8 POWER PHANTOM 48V 1 LINE INSTR INPUT 2 LINE INSTR MIX MON PHONES 1 MAX 3 MAX 4 MAX MAX GAIN 2 MAX 6 GAIN DIR LEVEL LEVEL 5 19 5. PHONES LEVEL Control This adjusts the level of the PHONES analog output on the front panel. Note: Make sure the PHONES LEVEL control is turned all the way down before plugging in your headphones. This will protect your hearing and prevent any loud surprises. 6. PHONES Jack The PHONES jack accepts a 1/4" TRS stereo plug normally used on headphones. If your headphones have a 1/8" mini-plug, you will need a 1/8" to 1/4" stereo adapter, commonly sold in electronics and audio stores. The headphone signals are the same as the Monitor Output signals, except the level is controlled by the PHONES LEVEL control instead of the MON LEVEL control. (The Monitor outputs and the Phones output are both affected by the MIX knob. ) 7. PHANTOM 48V Indicator This red LED lights up when the PHANTOM 48V switch [10] on the rear panel is engaged. 8. POWER Indicator The Link. USB is powered from the USB port. [. . . ] The address of your closest authorized service center will be given to you by Technical Support. IMPORTANT: Make sure that the Service Request Number is plainly written on the shipping carton. reserves the right to inspect any products that may be the subject of any warranty claims before repair or replacement is carried out. LOUD Technologies may, at our option, require proof of the original date of purchase in the form of a dated copy of the original dealer's invoice or sales receipt. [. . . ]