User manual TASCAM CD-01U

[. . . ] » CD PLAYER OWNER'S MANUAL D00864010A CD-01 U /CD-01UPro Important Safety Precautions O CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. This appliance has a serial number located on the rear panel. [. . . ] When incremental play function is activated, pressing this key play start from the next track. d READY key When this key is pressed during playback or while stopped, enters standby mode. f CALL key Locates the playback to the last play start point. gª STOP key Use this key to stop playback. When incremental play function is activated, pressing this key pauses at the beginning of the next track. TASCAM CD-01U/CD-01UPro 13 5 - Menu operation The various settings and editing operations possible with the CD-01U/CD-01U Pro are performed through menu options shown on the display. Menu Function Parameter Underlined values are factory default settings menu setting options, some may be made directly using the keys on the remote control. Manual reference Page 01 02 03 04 05 06 07 08 09 10 11 12 13 14 15 KEY-0 BLOCK REPEAT PROG FADE RELAY TIMER MONO RESUME EOM INCR PITCH RS232C F-PRE U-DATA Key Original Eject Block Repeat Playback A-B Repeat Playback Program Fade In/Out Relay Playback Fader/Event Start Power on Play Mono Output Resume EOM Time 25, 30, 35 sec. Incremental Play Pitch Step Baud rate setting Factory Preset User Data ON, OFF ON, OFF OFF, ON, A-B rogram operation OFF, 0. 5-10. 0 OFF, ON, FDR ON, OFF ON, OFF ON, OFF OFF, 5, 10, 15, 20, ON, OFF 0. 1, 0. 5, 1. 0 % 96, 192, 384 (SURE) ON, OFF Key Original Eject Block Repeat Playback Program Playback Fade In/Out Relay Play 23 Power on play Output in Mono Resume EOM Incremental Play Pitch Control Restoring the default setting ÆÆ 21 23 19 19 21 22 21 20 20 18 23 19 20 24 ÆÆ When digital output signal from the AES/EBU terminal is not received correctly on the other digital equipment , set the user data to OFF then try again. Operation basics 1 Press the PITCH knob on the front panel when SHIFT indicator is lit or press the MENU key on the remote control. Menu No. Menu Parameter 4 Use the PITCH knob on the front panel or PREV/NEXT keys on the remote control to select the setting value. 5 Press the PITCH knob on the front panel or ENTER key on the remote control. Pressing the DISPLAY key on either the front panel or the remote control exits the menu mode. 2 Use the PITCH knob on the front panel, or PREV/NEXT keys or number keys on the remote control to select the menu item. 3 Press the PITCH knob on the front panel or ENTER key on the remote control. 14 TASCAM CD-01U/CD-01U Pro 6 - Playback Discs for playback The CD-01U/ CD-01U Pro can playback the types of discs listed below. Ordinary audio CDs available commercially (recorded in CD-DA format). CD-R and CD-RW discs recorded in CD-DA format, and properly finalized. MP3 files recorded in ISO9660 format on CD-R and CD-RW discs, and properly finalized. CD-R/RW discs that have not been finalized cannot be played back. Make sure the disc has been properly finalized before loading into the player. About finalization Even if audio data is recorded onto a CD-R/RW disc, if the TOC (table of contents corresponding to the recorded data) is not written on the disc after recording, the disc cannot be played back on conventional CD players. Finalization is the process of writing the TOC on the disc. A number of record companies have released titles on copy control CD discs as a means of protecting artist copyrights. Some of these discs do not comply with standard CD format specifications, and may not be able to be played on this unit. The CD-01U/CD-01U Pro can play back MP3 files recorded in formats which conform to ISO9660 level 1, level 2 and Joliet. For MP3 CDs CDs containing MP3 files can be played by the CD01U/CD-01U Pro with the following limitations on the number of files and directories. Maximum number of directories: 254 Maximum number of MP3 files: 255 File format: MPEG 1 audio layer 3 Bit rate: 32kbps to 320kbps Sampling frequency: 44. 1KHz, Stereo File extension: mp3, Mp3, mP3, MP3 MP3 files are played as the order in the following diagram. In this manner, playback is performed from the top level directories. The CD-01U/CD-01U Pro can only read the files in the first session of a multi-session disc. ID3 tag display for MP3 playback is not supported. : Folder (Directory) : MP3 File TASCAM CD-01U/CD-01UPro 15 6 - Playback Playback modes There are four different playback modes. [. . . ] Switch on power to all the CD-01Us. RELAY IN RELAY OUT RELAY IN RELAY OUT RELAY OUT RELAY IN RELAY IN RELAY OUT RELAY IN 22 TASCAM CD-01U/CD-01UPro 7 - Advanced operations Time display switching During audio CD playback (or playback standby), when the DISPLAY key on either the front panel or the remote control is pressed, the time display will switch through several modes in the following order. Elapsed track time (no display light indication) Remaining track time (REMAIN is lit in the display) Remaining disc time (T. and REMAIN are lit in the display) When stopped, the total recording time is shown, regardless of the status of the TOTAL and REMAIN indicators. When playing an MP3 disc, elapsed track time is always displayed, and the DISPLAY key does not operate. [. . . ]