User manual TASCAM CD-450

[. . . ] » CD-450 Compact Disc Player 9101423400 OWNER'S MANUAL Ü ÿ Y This appliance has a serial number located on the rear panel. Please record the model number and serial number and retain them for your records. Model number Serial number CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. . [. . . ] b) if liquid has been spilled, or objects have fallen into the product. c) if the product has been exposed to rain or water. d) if the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation. e) if the product has been dropped or damaged in any way. f ) when the product exhibits a distinct change in performance ­ this indicates a need for service. 21) Replacement Parts -- When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock, or other hazards. 22) Safety Check -- Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition. 23) Wall or Ceiling Mounting -- The product should be mounted to a wall or ceiling only as recommended by the manufacturer. 24) Heat -- The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat. TASCAM CD-450 3 SAFETY INFORMATION This product has been designed and manufactured according to FDA regulations "title 21, CFR, chapter 1, subchapter J, based on the Radiation Control for Health and Safety Act of 1968", and is classified as a class 1 laser product. There is no hazardous invisible laser radiation during operation because invisible laser radiation emitted inside of this product is completely confined in the protective housings. The label required in this regulation is shown 1. CAUTION - DO NOT REMOVE THE PROTECTIVE HOUSING USING A SCREWDRIVER. - USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE. Do not drop this unit or subject it to severe impact. Internal circuits or the enclosure may be damaged. . . . Place this unit on horizontal and solid surfaces. There is a risk this unit overturns if installed on unstable shelves or stands. . . . When cleaning the exterior of this unit, use a soft cloth. To remove severe dirt, wipe it off with a soft cloth lightly moistened with neutral detergent and water. Never use any type of solvents such as benzine and thinner, which would damage the coating or erase legends. TASCAM CD-450 5 Specifications Disc: Audio channel: Quantization: Sampling frequency: Analog output level Line output (RCA) Nominal output level: 8-cm/12-cm CD 2 channels 16-bit linear 44. 1 kHz Power requirements: 120 V AC, 60 Hz (U. S. A. /Canada model) 230 V AC, 50 Hz (Europe/U. K. model) 240 V AC, 50 Hz (Australia model) Power consumption: 16 Watts External dimensions: 482 x 104. 5 x 310 mm Weight: 5. 1 kg Typical Performance Frequency response: Signal-to-Noise Ratio: Distortion: Channel separation: Pitch control: Auto cue level: ­10 dBv (load impedance 10kOhms, unbalanced) Maximum output level: +6 dBv (2Vrms) Line output (XLR) [Optional LA-450] Nominal output level: +4dBu (load impedance 10kOhms, balanced) Maximum output level: +20 dBu Headphone output (standard stereo phone jack): 25 mW at max. (load impedance 32Ohms) Digital output Coaxial (RCA): 20 Hz to 20 kHz (+/-1 dB) Better than 90 dB Less than 0. 006% Better than 85 dB Within +/-12% (1% steps) ­72/­66/­60/­54 dB IEC60958 home-use (SPDIF) Balanced (XLR) [Optional LA-450] : IEC60958 broadcasting studios (AES/EBU) * Changes in specifications and features may be made without notice or obligation. External Dimensions 6 TASCAM CD-450 General Guide 1 POWER Switch 2 Headphone Volume Control (PHONES) 3 Headphone Jack 4 Disc Tray 5 Numeric Keypad This is used to enter tack numbers, index numbers and time points. E PLAY Key F READY Key This key puts the deck into Ready-for-play mode. G CALL Key The point where you press PLAY to leave the ready mode and start playing is stored in memory, and you can go back to that point by pressing this CALL key. H AUTO READY Key When this key is pressed on, the deck goes into Ready mode at the beginning of each tack or at the beginning of an A-B loop. 6 CLEAR Key This key is used to clear wrong numbers you'll enter on the numeric keypad or to clear all your preference settings (p. 9) at once. I AUTO CUE Key When this key is pressed on and you perform a track search, the deck goes into Ready mode at the "first audio" of that track. [. . . ] When the total play time exceeds 999 minutes 59 seconds, the display will read "ExxMxxS. " By operating the "+" and "­" keys of PITCH CONT you can change the pitch within the limits of ±12% in 1% steps. The pitch percent value is shown in the INDEX display window. Press the PITCH CONT switch to let its LED light up, then press PLAY to start play at the entered pitch. Alternatively, you can press the PITCH CONT switch before changing the pitch with the "+" and "­" keys. [. . . ]