User manual TASCAM DA-78HR QUICK START

[. . . ] Rewind to beginning and monitor tracks 7 & 8. Press SHIFT key so the indicator flashes Press the MENU key until the display briefly shows MAINTN-Press SUB MENU until the display briefly shows DEV TYPE Use the UP and DOWN ARROWS to choose the device you wish to emulate Press the SHIFT key so the indicator flashes. Press the MENU key until the display shows SYSTEM Press SUB MENU key until the display shows ID SELxx Use the UP and DOWN ARROWS to change the ID value The machine ID must be set to anything but 1(You would only use offsets if the DA-78HR was going to be used as a slave) Press the SHIFT key so the indicator lights Press the AUTO IN/OUT (OFFSET) key Use the UP and DOWN ARROWS to change the value Use the SHIFTED UP and DOWN ARROWS to move the cursor Press the SHIFT key so the indicator lights Press the MENU key until the display shows MIDI-- Press SUB MENU key until the display shows ID followed by the current ID # (1-127) Use the UP and DOWN ARROWS to change the MIDI ID number. [. . . ] The DA-78HR has many powerful features that even the most seasoned professional will miss out on unless you read the manual to discover its depth!Here is a basic idea of how to get around on the DA-78HR. Most of the editable parameters on the unit are accessed using four keys. When the SHIFT key has been pressed with it's indicator blinking, the REPEAT/MENU key is the gateway to the menus of the DA-78HR. When the MENU key is pressed, one of these groups names are displayed on the screen and the unit enters menu mode. Continually pressing the MENU key will step you through the eight different menus in a circular fashion. You'll notice that there are two dashes (--) after the name of each menu. This is telling you that there are sub-menus under this level. When a menu is displayed, pressing the SUB MENU key brings up the sub-menus associated with that menu. Continually pressing the SUB MENU key cycles through the different sub-menus. The UP and DOWN ARROW keys are used to change the value of the parameters within these menus and sub-menus. Pushing both ARROW keys simultaniously will change the current parameter's value back to the default setting. Some parameters have multiple values displayed on the screen at one time. For instance a SMPTE start time will look like this 01:23:46:15. There is a blinking cursor behind the hour value. To move the cursor to the right you would hold down SHIFT key and press the UP ARROW key. Note: As you follow these instructions, in some cases the display may change to a default sub menu after briefly displaying information. Nonetheless, continue to follow the steps as listed to complete the desired function. Press the SHIFT key so the indicator light flashes Press the MENU key until the display shows MAINTN-- Press the SUB MENU key until the display shows INIT Press the UP ARROW key to change the display to read READY Press the UP ARROW key again to restore factory settings The unit will show DONE and restart. [. . . ] Press the SHIFT key so the indicator light goes out. Press LOC 1 and the DA-78 will park at 5 seconds before your punch in time. Press play and after the 5 second pre-roll the DA-78 will automatically go in and out of record at the times you programmed. [. . . ]