User manual TASCAM DA-88 annexe 1

[. . . ] Press DISPLAY to exit Press DISPLAY to exit Press DISPLAY + to Exit or DISPLAY to go to Punch out point Press DISPLAY + to Exit Press DISPLAY + to Exit Use or to scroll through letters. Press DISPLAY after each correct letter. Press & when done to Exit message mode. Track Meters 1 & 2 show Block Error Rate in real time for playback heads A & B This enters the SY-88 Menu system This will exit SY-88 Menu system Allows front panel Record command on slave units. [. . . ] S-Err-03 Combination of Errors 1 & 2 S-Err-04 Capstan Motor Problem. The motor spin command is given, but no FG signal is detected within 1. 5 seconds. S-Err-05 Combination of Errors 1 & 4 S-Err-06 Combination of Errors 2 & 4 S-Err-07 Combination of Errors 1, 2 &4 S-Err-08 Reel Problem (take-up or supply). No FG received from either reel table for 1. 5 seconds. S-Err-09 Combination of Errors 1 & 8 S-Err-10 Combination of Errors 2 & 8 S-Err-11 Combination of Errors 1, 2 & 8 (a mechanical mode change is not completed within 5 seconds). S-Err-12 Combination of Errors 4 & 8 S-Err-13 Combination of Errors 1, 4 & 8 S-Err-14 Combination of Errors 2, 4 & 8 S-Err-15 Combination of Errors 1, 2, 4 & 8 S-Err-21 The reel tables do not wind the tape in preparation for Eject. Tape width varies within a specified tolerance. If the tape path has been adjusted for a narrow or easily flexed tape, a wider or stiffer tape may get caught in the guides. The System control monitors both reel table tachometers, as well as the Head and Capstan tachs. Any conflicting information will halt the transport. S-Err-41 The solenoid does not engage during FF/RW (100x speed). S-Err-59 In Eject mode, the reels do not start to drive, or do not lock for more than 1. 5 seconds S-Err-68 In Play mode, the reels do not start to drive, or do not lock for more than 1. 5 seconds. E. CLOC No clock data, or incorrect setting of the clock switch or machine time base reference. This could also indicate a mismatch in the machine ID K numbers and/or missing sync signal such as video or word clock. No digital device is detected at the T-DIF port. Check to see if cables are connected and power is on. You must use TASCAM cables or other individually shielded twisted pair cable. E. dE Dew sensor has detected condensation on the head drum. [. . . ] 2) With Power off, connect Source DA-88 DIGITAL I/O port to Target DIGITAL I/O port using the PW-88D Digital Dubbing cable. If dubbing Time code, connect TC Out from source DA-88 to TC In on the target DA-88 using the RCA to RCA audio cable. 3) Power On both DA-88s 4) On the Source DA-88, enter a 43 Fs Track Delay value for all 8 tracks. The display will toggle between Analog and Digital. [. . . ]